ObjectivesTo determine how to most accurately predict the chance of spontaneous passage of a ureteral stone using information in the diagnostic non-enhanced computed tomography (NECT) and to create predictive models with smaller stone size intervals than previously possible.MethodsRetrospectively 392 consecutive patients with ureteric stone on NECT were included. Three radiologists independently measured the stone size. Stone location, side, hydronephrosis, CRP, medical expulsion therapy (MET) and all follow-up radiology until stone expulsion or 26 weeks were recorded. Logistic regressions were performed with spontaneous stone passage in 4 weeks and 20 weeks as the dependent variable.ResultsThe spontaneous passage rate in 20 weeks was 312 out of 392 stones, 98% in 0–2 mm, 98% in 3 mm, 81% in 4 mm, 65% in 5 mm, 33% in 6 mm and 9% in ≥6.5 mm wide stones.The stone size and location predicted spontaneous ureteric stone passage. The side and the grade of hydronephrosis only predicted stone passage in specific subgroups.ConclusionSpontaneous passage of a ureteral stone can be predicted with high accuracy with the information available in the NECT. We present a prediction method based on stone size and location.Key Points• Non-enhanced computed tomography can predict the outcome of ureteral stones.• Stone size and location are the most important predictors of spontaneous passage.• Prediction models based on stone width or length and stone location are introduced.• The observed passage rates for stone size in mm-intervals are reported.• Clinicians can make better decisions about treatment.

Qualitative evaluation of the usefulness of several MAR techniques from different vendors in CT imaging of hip prosthesis.

Computed tomography (CT) is the method of choice for diagnosing ureteral stones - kidney stones that obstruct the ureter. The purpose of this study is to develop a computer aided detection (CAD) algorithm for identifying a ureteral stone in thin slice CT volumes. The challenge in CAD for urinary stones lies in the similarity in shape and intensity of stones with non-stone structures and how to efficiently deal with large high-resolution CT volumes. We address these challenges by using a Convolutional Neural Network (CNN) that works directly on the high resolution CT volumes. The method is evaluated on a large data base of 465 clinically acquired high-resolution CT volumes of the urinary tract with labeling of ureteral stones performed by a radiologist. The best model using 2.5D input data and anatomical information achieved a sensitivity of 100% and an average of 2.68 false-positives per patient on a test set of 88 scans.

The objectives were to develop and validate a Convolutional Neural Network (CNN) using local features for differentiating distal ureteral stones from pelvic phleboliths, compare the CNN method with a semi-quantitative method and with radiologists' assessments and to evaluate whether the assessment of a calcification and its local surroundings is sufficient for discriminating ureteral stones from pelvic phleboliths in non-contrast-enhanced CT (NECT). We retrospectively included 341 consecutive patients with acute renal colic and a ureteral stone on NECT showing either a distal ureteral stone, a phlebolith or both. A 2.5-dimensional CNN (2.5D-CNN) model was used, where perpendicular axial, coronal and sagittal images through each calcification were used as input data for the CNN. The CNN was trained on 384 calcifications, and evaluated on an unseen dataset of 50 stones and 50 phleboliths. The CNN was compared to the assessment by seven radiologists who reviewed a local 5 × 5 × 5 cm image stack surrounding each calcification, and to a semi-quantitative method using cutoff values based on the attenuation and volume of the calcifications. The CNN differentiated stones and phleboliths with a sensitivity, specificity and accuracy of 94%, 90% and 92% and an AUC of 0.95. This was similar to a majority vote accuracy of 93% and significantly higher (p = 0.03) than the mean radiologist accuracy of 86%. The semi-quantitative method accuracy was 49%. In conclusion, the CNN differentiated ureteral stones from phleboliths with higher accuracy than the mean of seven radiologists' assessments using local features. However, more than local features are needed to reach optimal discrimination. Keywords Computed tomography • Ureteral calculi • Pelvic phlebolith • Deep learning • Convolutional neural networks Abbreviations NECT Non-contrast-enhanced computed tomography CTU CT urography CNN Convolutional neural network 2.5D-CNN 2.5-Dimensional CNN including axial, coronal and sagittal images CAD Computer-aided diagnosis ANN Artificial neural network AI Artificial intelligence FC layer Fully connected layer PACS Picture archiving and communication system MPR Multiplanar reconstructions CI Confidence interval ROC Receiver operating characteristic AUC Area under the curve ROI Region of interest Key points A Convolutional Neural Network for classifying pelvic calcifications was developed and validated.

ObjectivesTo compare the ability of different size estimates to predict spontaneous passage of ureteral stones using a 3D-segmentation and to investigate the impact of manual measurement variability on the prediction of stone passage.MethodsWe retrospectively included 391 consecutive patients with ureteral stones on non-contrast-enhanced CT (NECT). Three-dimensional segmentation size estimates were compared to the mean of three radiologists’ measurements. Receiver-operating characteristic (ROC) analysis was performed for the prediction of spontaneous passage for each estimate. The difference in predicted passage probability between the manual estimates in upper and lower stones was compared.ResultsThe area under the ROC curve (AUC) for the measurements ranged from 0.88 to 0.90. Between the automated 3D algorithm and the manual measurements the 95% limits of agreement were 0.2 ± 1.4 mm for the width. The manual bone window measurements resulted in a > 20 percentage point (ppt) difference between the readers in the predicted passage probability in 44% of the upper and 6% of the lower ureteral stones.ConclusionsAll automated 3D algorithm size estimates independently predicted the spontaneous stone passage with similar high accuracy as the mean of three readers’ manual linear measurements. Manual size estimation of upper stones showed large inter-reader variations for spontaneous passage prediction.Key points• An automated 3D technique predicts spontaneous stone passage with high accuracy.• Linear, areal and volumetric measurements performed similarly in predicting stone passage.• Reader variability has a large impact on the predicted prognosis for stone passage.

Background Iterative reconstruction (IR) is a recent reconstruction algorithm for computed tomography (CT) that can be used instead of the standard algorithm, filtered back projection (FBP), to reduce radiation dose and/or improve image quality. Purpose To evaluate and compare the image quality of low-dose CT of the lumbar spine reconstructed with IR to conventional FBP, without further reduction of radiation dose. Material and Methods Low-dose CT on 55 patients was performed on a Siemens scanner using 120 kV tube voltage, 30 reference mAs, and automatic dose modulation. From raw CT data, lumbar spine CT images were reconstructed with a medium filter (B41f) using FBP and four levels of IR (levels 2-5). Five reviewers scored all images on seven image quality criteria according to the European guidelines on quality criteria for CT, using a five-grade scale. A side-by-side comparison was also performed. Results There was significant improvement in image quality for IR (levels 2-4) compared to FBP. According to visual grading regression, odds ratios of all criteria with 95% confidence intervals for IR2, IR3, IR4, and IR5 were: 1.59 (1.39-1.83), 1.74 (1.51-1.99), 1.68 (1.46-1.93), and 1.08 (0.94-1.23), respectively. In the side-by-side comparison of all reconstructions, images with IR (levels 2-4) received the highest scores. The mean overall CTDI was 1.70 mGy (SD 0.46; range, 1.01-3.83 mGy). Image noise decreased in a linear fashion with increased strength of IR. Conclusion Iterative reconstruction at levels 2, 3, and 4 improves image quality of low-dose CT of the lumbar spine compared to FPB.

Objectives To prospectively validate three quantitative single-energy CT (SE-CT) methods for classifying uric acid (UA) and non-uric acid (non-UA) stones. Methods Between September 2018 and September 2019, 116 study participants were prospectively included in the study if they had at least one 3–20-mm urinary stone on an initial urinary tract SE-CT scan. An additional dual-energy CT (DE-CT) scan was performed, limited to the stone of interest. Additionally, to include a sufficient number of UA stones, eight participants with confirmed UA stone on DE-CT were retrospectively included. The SE-CT stone features used in the prediction models were (1) maximum attenuation (maxHU) and (2) the peak point Laplacian (ppLapl) calculated at the position in the stone with maxHU. Two prediction models were previously published methods (ppLapl-maxHU and maxHU) and the third was derived from the previous results based on the k-nearest neighbors (kNN) algorithm (kNN-ppLapl-maxHU). The three methods were evaluated on this new independent stone dataset. The reference standard was the CT vendor’s DE-CT application for kidney stones. Results Altogether 124 participants (59 ± 14 years, 91 men) with 106 non-UA and 37 UA stones were evaluated. For classification of UA and non-UA stones, the sensitivity, specificity, and accuracy were 100% (37/37), 97% (103/106), and 98% (140/143), respectively, for kNN-ppLapl-maxHU; 95% (35/37), 98% (104/106), and 97% (139/143) for ppLapl-maxHU; and 92% (34/37), 94% (100/106), and 94% (134/143) for maxHU. Conclusion A quantitative SE-CT method (kNN-ppLapl-maxHU) can classify UA stones with accuracy comparable to DE-CT. Key Points • Single-energy CT is the first-line diagnostic tool for suspected renal colic. • A single-energy CT method based on the internal urinary stone attenuation distribution can classify urinary stones into uric acid and non-uric acid stones with high accuracy. • This immensely increases the availability of in vivo stone analysis.

Purpose To externally validate five previously published predictive models (Ng score, Triple D score, S3HoCKwave score, Kim nomogram, Niwa nomogram) for shock wave lithotripsy (SWL) single-session outcomes in patients with a solitary stone in the upper ureter. Methods Patients treated with SWL from September 2011 to December 2019 were included in a retrospective analysis. Patient-related variables were collected from the hospital records. Stone-related data including all measurements were retrieved from computed tomography prior to SWL. We estimated discrimination using area under the curve (AUC), calibration, and clinical net benefit based on decision curve analysis (DCA). Results A total of 384 patients with proximal ureter stones treated with SWL were included in the analysis. Median age was 55.5 years, and 282 (73%) of the sample were men. Median stone size was 8.0 mm. All models significantly predicted the SWL outcomes after one session. S3HoCKwave score, Niwa, and Kim nomograms had the highest accuracy in predicting outcomes, with AUC 0.716, 0.714 and 0.701, respectively. These three models outperformed both the Ng (AUC: 0.670) and Triple D (AUC: 0.667) scoring systems, approaching statistical significance (P = 0.05). Of all the models, the Niwa nomogram showed the strongest calibration and highest net benefit in DCA. Conclusions The models showed small differences in predictive power. The Niwa nomogram, however, demonstrated acceptable discrimination, the most accurate calibration, and the highest net benefit whilst having relatively simple design. Therefore, it could be useful for counselling patients with a solitary stone in the upper ureter.