Resumo Um dos critérios para avaliar a condição da superfície usinada é o processo de remoção do material utilizado. No caso específico de materiais endurecidos, nas operações de acabamento, o processo de torneamento está se tornando uma alternativa à retificação. Mas obter peças com rugosidade Ra menor que 0,2 μm no torneamento demateriais endurecidos sempre foi um desafio para a indústria metalmecânica. Diante deste cenário, o objetivo do presente trabalho é analisar o acabamento da superfície em torneamento do aço AISI 52100 em dois diferentes valores de dureza-35 HRC e 55 HRC-com ferramentas de PCBN e de metal duro, a fim de verificar se o acabamento superfície obtida utilizando uma ferramenta de menor custo é igual ao obtido com as ferramentas PCBN. Verificou-se que tanto o PCBN quanto a ferramenta de metal duro obtiveram valores de rugosidade muito próximos para a usinagem do aço AISI 52100 com dureza de 35 HRC. No entanto, em um nível mais elevado de dureza, observou-se uma disparidade no desempenho das duas ferramentas, obtendo a ferramenta de PCBN valores mais baixos de rugosidade. Palavras-chave: Rugosidade; Acabamento da superfície; Torneamento de materiais endurecidos.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.