No abstract

This is the first report from the JAGUARS (JApanese-German Underground Acoustic Emission Research in South Africa) project, the overall aim of which is to observe ultra-small fracturing in a more or less natural environment. We installed a local (∼40-m span) network of eight acoustic emission (AE) sensors, which have the capability to observe up to 200 kHz at a depth of 3.3 km in a South African gold mine. Our specific objective was to monitor a 30-m thick dyke that remains as a dip pillar against active mining ∼90 m above our network. An M w 1.9 earthquake whose hypocenter was ∼30 m above the network occurred in the dyke. Although the mineowned geophone (4.5 Hz) network detected only five earthquakes in the surrounding 200×200×150-m 3 volume within the first 150 h following the main shock, our AE network detected more than 20,000 earthquakes in the same period. More than 13,000 of these formed a distinct planar cluster (∼100×80 m 2 ) on which the main shock hypocenter lay, suggesting that this cluster delineates the main shock rupture plane. Most of the aftershocks were presumably very small, probably as low as M ∼ −4. The aftershock cluster dipped ∼60• . This is consistent with normal faulting under a nearly vertical compression field, as indicated by nearly horizontal breakouts found in a borehole crossing the rupture plane.

Using a network of sensitive high-frequency acoustic emission sensors, we observed foreshock activity of an Mw 2.2 earthquake (main shock) in a deep gold mine in South Africa. Foreshock activity, which selectively occurred on a part of the rupture plane of the forthcoming main shock, lasted for at least 6 months until the main shock. Rock samples recovered from the main shock source region showed evidence of ancient hydrothermal alteration on the main shock rupture plane, suggesting that the foreshock activity occurred on a preexisting weakness. The foreshocks during 3 months before the main shock were concentrated in three clusters (F1-F3), which we interpret as representing localized preslip at multiple sites. While the location of mining area, the source of stress perturbations, changed with time, the locations of foreshock clusters did not change, suggesting that the preslip patches were controlled by strength heterogeneity rather than stress distribution. Activity over the entire foreshock area was generally constant, but the largest cluster (F2) showed accelerated activity starting at least 7 days before the main shock, while mining stress did not increase in this period. The main shock initiated at a point close to F1, away from F2. All the six foreshocks during the final 41 h occurred in F1 and F2 and in-between. These suggest that in the last stage of the preparation process of the main shock, preslip patches interacted with each other through the stress concentration ahead of the expanding preslip patch (F2), which should be the only driving force of the preparation process under the constant external load.

a b s t r a c tWe applied advanced mapping techniques to 291 230 acoustic emission (AE) events as small as around M À 4 that were recorded over 50 days by an ultra-high resolution network close to the active front of a tabular mining stope being advanced northward at 1 km depth in the Cooke 4 Gold Mine in South Africa. We first applied joint hypocenter determination (JHD) to improve absolute locations, and then applied the double-difference relative location algorithm to the JHD output. These steps resolved the seemingly continuous, dense cloud of AEs that extend about 20 m ahead of the stope front into several discrete, steeply dipping tabular clusters a few meters thick and 10-30 m in dip extent, separated by quiet intervals a few meters thick. The clusters have a strike parallel to the stope face and a dip of about 65°, resembling commonly observed large shear fractures along the plane of maximum shear (Ortlepp shears). In general, the activity of the clusters changed in similar ways as the stope face advanced, but each cluster remained stationary and the gaps between clusters were impressively quiet. This study demonstrates that high-resolution AE mapping can delineate the formation of large structures of localized damage in the highly stressed intact rock mass ahead of the stope face, a process that may culminate in hazardous seismic events.

Three months of acoustic emission (AE) monitoring in a South African gold mine down to M w À5 revealed a newly emergent planar cluster of 7557 events À3.9 ≤ M w ≤ À1.8 (typical rupture radius of 6-70 cm) that expanded with time to reach a size of 20 m on a preexisting geological fault near an active mining front 1 km beneath the ground. It had a sharply defined, planar configuration, with hypocenters aggregated within a thickness of only several decimeters. We infer that the zone defines an aseismic slip patch on the fault, wherein the individual AEs represent failures of very small asperities being loaded by the aseismic slip. Additional support for the interpretation was obtained by analyzing composite focal mechanisms and repeating events. The patch expansion over 2 months was likely quasistatic because all individual AEs ruptured much smaller areas than the cluster size at the corresponding time. The b values dropped gradually from 2.6 to 1.4, consistent with a significant increase in shear stress expected of the mining style. Another cluster with similar characteristics emerged later on a neighboring part of the same fault and grew to a 10 m extent in the last weeks of the study period. The quasi-static expansion of inferred localized slow-slip patches to sizes of 10-20 m suggests that the critical crack length on natural faults can be at least as large, much exceeding the decimeter range derived from laboratory stick-slip experiments on saw-cut rocks.