Post-Caledonian extension during orogenic collapse and Mesozoic rifting in the West Norway-northern North Sea region was accommodated by the formation and repeated reactivation of ductile shear zones and brittle faults. Offshore, the Late Palaeozoic-Mesozoic rift history is relatively well known; extension occurred mainly during two rift phases in the Permo-Triassic (Phase 1) and Mid-Late Jurassic (Phase 2). Normal faults in the northern North Sea, e.g., on the Horda Platform, in the East Shetland Basin and in the Viking Graben, were initiated or reactivated during both rift phases. Onshore, on the other hand, information on periods of tectonic activity is sparse as faults in crystalline basement rocks are difficult to date. KAr dating of illite that grows synkinematically in fine-grained fault rocks (gouge) can greatly help to determine the time of fault activity, and we apply the method to nine faults from the Bergen area. The K-Ar ages are complemented with X-ray diffraction analyses to determine the mineralogy, illite crystallinity and polytype composition of the samples. Based on these new data, four periods of onshore fault activity could be defined: (1) the earliest growth of fault-related illite in the Late Devonian-Early Carboniferous (>340 Ma) marks the waning stages of orogenic collapse; (2) widespread latest Carboniferous-Mid Permian (305-270 Ma) fault activity is interpreted as the onset of Phase 1 rifting, contemporaneous with rift-related volcanism in the central North Sea and Oslo Rift; (3) a Late Triassic-Early Jurassic (215-180 Ma) period of onshore fault activity postdates Phase 1 rifting and predates Phase 2 rifting and is currently poorly documented in offshore areas; and (4) Early Cretaceous (120-110 Ma) fault reactivation can be linked either to late Phase 2 North Sea rifting or to North Atlantic rifting.

<p>Brittle fracture and fault networks control the location of topographic features such as valleys and ridges and active faulting can lead to topographic rejuvenation. In Western Norway, however, it is debated how much faulting has contributed to rejuvenating of the topography during the late Mesozoic and Cenozoic. Geometric and temporal constraints on the brittle evolution are therefore important to obtain a comprehensive picture of the post-Caledonian topographic evolution of this region. In this study, we combine remote sensing, structural field measurements, paleo-stress analysis and isotopic dating to study the brittle evolution of a larger region of Western Norway. The region spans from the Sognefjord in the south to the Møre margin in the north. Lineament studies reveal important lineament sets trending N-S, NE-SW, E-W and NW-SE. Field observations show that these lineament sets correspond to both dip-slip and strike-slip faults, some of them parallel to ductile precursor structures and some cutting the ductile fabric. Epidote, chlorite, quartz and zeolite are the dominant mineralizations on fracture and fault surfaces. There is no clear correlation between the type of mineralization and fracture orientation in the region. Paleostress analysis on fault-slip data (n = 173), including faults reactivating older structures, show a good fit with a general E-W extensional regime. However, a considerable amount of faults (n = 115) formed under a strike-slip regime, which has so far not been documented in the region. We combine these findings with K-Ar fault gouge dating from six faults where five fractions (6-10 µm, 2-6 µm, 0.4-2 µm, 0.1-0.4 µm, <0.1µm) from each sample were analysed. These faults represent two of the four fracture sets observed, trending N-S and NE-SW, respectively, and show either strike-slip or dip-slip kinematics. XRD-data from these gouges show that K-feldspar and smectite are the main sources of potassium. The ages show a spread from the Triassic to the Cretaceous, where older ages can be affected by K-feldspar inherited from the host rock. Our results point to an important phase of Mesozoic strike-slip faulting in the region, with steep faults controlling the location of several major valleys. Extensional dip-slip faults might have contributed to the rejuvenation of the footwall topography.</p>

In their paper, Kao and Rankin present a technique designed to enhance the signal‐to‐noise ratio of magnetotelluric (MT) data. In particular, they claim it can remove the noise from the autopower estimates of MT data if the cross‐power estimates are noise free and, hence, increase the coherency of the data. We present a hypothetical, but realistic, example which we feel raises serious questions related to the general validity of the technique.

No abstract

No abstract

No abstract

No abstract

No abstract