Natural gas (NG) engines have very broad application prospects. The pilot-ignited NG diesel engine can be organized into two combustion modes according to the sequence of oil and gas injection: (1) High-pressure direct injection, where NG is mainly diffused combustion; and (2) partially premixed compression ignition, where NG is mainly premixed combustion. In this study, we used CONVERGE to explore the influence of the NG injection timing on the distribution of the mixture equivalence ratio, ignition characteristics, thermal efficiency, emission, and combustion reaction rate under the two combustion modes. We also used a multi-step soot model to analyze the particle mass and quantity. We showed herein that the NG injection timing significantly affects the mixture distribution in the cylinder, thereby consequently affecting the combustion process. Both very early and very late injection times were not conducive to NG combustion. In addition, the mass, quantity, and diameter of the soot produced by diffusion combustion were larger than those produced with premixed combustion.
The direct injection of natural gas (NG), which is an important research direction in the development of NG engines, has the potential to improve thermal efficiency and emissions. When NG engines operate in low-load conditions, combustion efficiency decreases and hydrocarbon (HC) emissions increase due to lean fuel mixtures and slow flame propagation speeds. The effect of two combustion modes (partially premixed compression ignition (PPCI) and high pressure direct injection (HPDI)) on combustion processes was investigated by CFD (Computational Fluid Dynamics), with a focus on different injection strategies. In the PPCI combustion mode, NG was injected early in the compression stroke and premixed with air, and then the pilot diesel was injected to cause ignition near the top dead center. This combustion mode produced a faster heat release rate, but the HC emissions were higher, and the combustion efficiency was lower. In the HPDI combustion mode, the diesel was injected first and ignited, and then the NG was injected into the flame. This combustion mode resulted in higher emissions of NOx and soot, with a diffusion combustion in the cylinder. HC emissions significantly decreased. Compared with PPCI combustion, HPDI had a higher thermal efficiency.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.