This study introduces a simple analytical model for fracture toughness to bridge the length scales from grain size to bulk thickness by assembling a virtual crack path from the angles recorded on an unfractured microstructure, which is a great challenge in fracture mechanics due to the high geometrical complexity. Good agreement is found between a crack deflection angle distribution measured from 5764 crack segments and the prediction by the model and the possible influence of residual stress is quasi quantitatively discussed. A total of 7.4% of the crack segments observed acted as crack bridges, while 7.3% was predicted by the model. A quantification of how high an angle needs to be to turn crack deflection into crack bridging is given. The ratio of fracture toughness from grain boundary to grain, G 1c(gb) /G 1c(g) , was measured indirectly from all samples to be between 0.3 and 0.35.
Germanium alloyed with α-tin (GeSn) transitions to a direct bandgap semiconductor of significance for optoelectronics. It is essential to localize the carriers within the active region for improving the quantum...
Intermediate temperature creep properties are considered a key indicator of single crystal superalloys used for turbine blades of aircraft engines. The interrupted and ruptured creep tests were carried out in a second generation single crystal superalloy under the conditions of 760°C/785MPa. The creep rupture life as well as minimum creep rate were also in the same level of those in CMSX-4 and PWA1484. The microstructural evolution at different creep stages were analyzed by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The results showed the γ’ phases kept the cuboid morphology mostly until the creep rupture, and super lattice stacking faults (SSFs) extended along [-1 1 0] and [-1-1 0] orientations within the γ’ precipitate were the typical dislocation configuration.
The compliance matrix for a general anisotropic material is usually expressed in an arbitrarily chosen coordinate system, which brings some confusion or inconvenience in identifying independent elastic material constants and comparing elastic properties between different materials. In this paper, a unique stiffest orientation-based standardized compliance matrix is established, and 18 independent elastic material constants are clearly shown. During the searching process for the stiffest orientation, it is interesting to find from our theoretical analysis and an example that a material with isotropic tensile stiffness does not definitely possess isotropic elasticity. Therefore, the ratio between the maximum and minimum tensile stiffnesses, although widely used, is not a correct measure of anisotropy degree. Alternatively, a simple and correct measure of anisotropy degree based on the maximum shear-extension coupling coefficient in all orientations is proposed. However, for a two-dimensional constitutive relation, both the stiffness ratio and the shear-extension coupling coefficient can be adopted as proper measures of anisotropy degree.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.