Previously, the primary product distribution resulting from fast pyrolysis of cellulose, hemicellulose, and lignin was quantified. This study extends the analysis to the examinations of interactions between cellulose-hemicellulose and cellulose-lignin, which were determined by comparing the pyrolysis products from their native mixture, physical mixture, and superposition of individual components. Negligible interactions were found for both binary physical mixtures. For the native cellulose-hemicellulose mixture, no significant interaction was identified either. In the case of the native cellulose-lignin mixture, herbaceous biomass exhibited an apparent interaction, represented by diminished yield of levoglucosan and enhanced yield of low molecular weight compounds and furans. However, such an interaction was not found for woody biomass. It is speculated that these results are due to different amounts of covalent linkages in these biomass samples. This study provides insight into the chemistry involved during the pyrolysis of multicomponent biomass, which can facilitate building a model for bio-oil composition prediction.
Fischer–Tropsch synthesis (FTS) is a promising technology to convert syngas derived from non-petroleum-based resources to valuable chemicals or fuels. Selectively producing target products will bring great economic benefits, but unfortunately it is theoretically limited by Anderson–Schulz–Flory (ASF) law. Herein, we synthesize size-uniformed cobalt nanocrystals embedded into mesoporous SiO2 supports, which is likely the structure of water-melon seeds inside pulps. We successfully tune the selectivity of products from diesel-range hydrocarbons (66.2%) to gasoline-range hydrocarbons (62.4%) by controlling the crystallite sizes of confined cobalt from 7.2 to 11.4 nm, and modify the ASF law. Generally, larger Co crystallites increase carbon-chain growth, producing heavier hydrocarbons. But here, we interestingly observe a reverse phenomenon: the uniformly small-sized cobalt crystallites can strongly adsorb active C* species, and the confined structure will inhibit aggregation of cobalt crystallites and escape of reaction intermediates in FTS, inducing the higher selectivity towards heavier hydrocarbons.
An experimental observation of fast-moving plasma bullets produced in an atmospheric dielectric-barrier discharge jet is reported in this paper. Nanosecond imaging suggests that the atmospheric discharge jet consists of a plasma bullet train traveling at a hypersonic speed from 7.0km∕sto43.1km∕s. Yet on a millisecond scale, the bullet train appears as a plasma jet of several centimeters long. The plasma bullets are produced through several possible mechanisms, the most likely of which is related to the ionization wave. Time and space resolved optical emission spectroscopy show that reactive plasma species can be delivered to different spatial sites with varying quantities.
Upconversion is a nonlinear optical phenomenon that involves the emission of high‐energy photons by sequential absorption of two or more low‐energy excitation photons. Due to their excellent physiochemical properties such as deep penetration depth, little damage to samples, and high chemical stability, upconversion nanoparticles (UCNPs) are extensively applied in bioimaging, biosensing, theranostic, and photochemical reactions. Here, recent achievements in the synthesis, optimization, and applications of UCNP‐based nanomaterials are reviewed. The state‐of‐the‐art approaches to synthesize UCNPs in the past few years are introduced first, followed by a summary of several strategies to optimize upconversion emissive properties and various applications of UCNPs. Lastly, the challenges and future perspectives of UCNPs are provided as a conclusion.
High‐efficiency all‐solid‐state dye‐sensitized nanocrystalline solar cells have been fabricated using a poly(ethylene oxide)/poly(vinylidene fluoride) (PEO/PVDF)/TiO2‐nanoparticle polymer redox electrolyte, which yields an overall energy‐conversion efficiency of about 4.8 % under irradiation by white light (65.2 mW cm–2). The introduction of PVDF (which contains the highly electronegative element fluorine) and TiO2 nanoparticles into the PEO electrolyte increases the ionic conductivity (by about two orders of magnitude) and effectively reduces the recombination rate at the interface of the TiO2 and the solid‐state electrolyte, thus enhancing the performance of the solar cell.
Structural flexibility can be a desirable trait of an operating catalyst because it adapts itself to a given catalytic process for enhanced activity. Here, amorphous cobalt hydroxide nanocages are demonstrated to be a promising electrocatalyst with an overpotential of 0.28 V at 10 mA cm , far outperforming the crystalline counterparts and being in the top rank of the catalysts of their kind, under the condition of electrocatalytic oxygen evolution reaction. From the direct experimental in situ and ex situ results, this enhanced activity is attributed to its high structural flexibility in terms of 1) facile and holistic transformation into catalytic active phase; 2) hosting oxygen vacancies; and 3) structure self-regulation in a real-time process. Significantly, based on plausible catalytic mechanism and computational simulation results, it is disclosed how this structural flexibility facilitates the kinetics of oxygen evolution reaction. This work deepens the understanding of the structure-activity relationship of the Co-based catalysts in electrochemical catalysis, and it inspires more applications that require flexible structures enabled by such amorphous nanomaterials.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.