Supercritical CO2 (ScCO2) is a drying medium with excellent solubility and mass transfer efficiency. Supercritical CO2 drying (SCD) can remove the water of wood rapidly and prevent a change of microstructure caused by capillary tension in the drying process. In this study, Eucalyptus urophylla × E. grandis specimens with lengths of 50 and 100 mm were dried with ScCO2. Conventional kiln drying (CKD) and oven-drying (OD) were used as control. After 1 h, the drying rate, shrinkage, moisture distribution, drying stress were measured to explore the influence of drying methods and specimen length for drying characteristics during the early drying stage. The results showed that compared with CKD and OD, water removal was the fastest under SCD, and the drying rate was nine times of CKD and one time of OD. The shrinkage of SCD was the lowest among the three drying methods. Moisture distribution of SCD and OD was uneven. The drying stress of SCD was relatively high, the drying stress index of it was almost five times of CKD and three times of OD. Regardless of the drying method, shorter specimens had a shorter drying period but greater drying defects than the long specimens.
Thermal modification (TM) improves the hydrophobicity, dimensional stability, and durability of wood, but TM commonly results in severe color change and mechanical strength loss as wood is treated at higher temperature. In this study, Pterocarpus macrocarpus Kurz wood was thermally modified at moderate temperature (150 °C) and higher temperature (200 °C), and subsequently TM wood at 150 °C was subjected to wax impregnation (WI), the effect of a combination of TM and WI on the hygroscopicity, dimensional stability, and mechanical properties, as well as the micro-structure of wood, were investigated and compared. The results showed that the mass loss of wood was slight at 150 °C TM, while it became severe at 200 °C TM conditions. TM conditions affected the amount of the subsequent wax impregnation; the equilibrium moisture content (EMC), water absorption ratio, and adsorption and absorption swelling of the 150 °C TM + WI group were lower than that of 200 °C TM, and presented the lowest value. Moderate temperature TM could improve the hydrophobicity and dimensional stability of wood, but WI played a key role in the improvement. TM decreased the modulus of rupture (MOR) of wood, while WI improved the MOR. TM increased the modulus of elasticity (MOE) of wood, but WI had little effect on MOE; Scanning electron microscope (SEM) observation showed that the wax was successfully impregnated into the wood interior, and presented an even distribution on the internal surfaces of wood cells; Fourier-transform infrared spectroscopy (FTIR) spectra verified the changes of –OH and C=O after TM and TM + WI, which contributed to decreasing hygroscopicity and improving the dimensional stability of the wood. Impregnated wax improved wood mechanical strength, but decreased the lightness, and deepened the color of wood. The combination of thermal modification at moderate temperature with subsequent wax impregnation is a practical approach for improving wood properties.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.