In this work, a multi-physics field coupling model based on electric field, gas-liquid two-phase flow field ,and temperature field of forward flow electrochemical trepanning (FFECT) blades was established, and the distribution law of hydrogen bubble volume fraction, electrolyte temperature, and electrolyte conductivity in the machining gap was obtained. Based on the simulation results, the time-varying process of electrolyte flow velocity distribution was divided into three stages according to the change in machining gap corresponding to different blade machining heights H, and the effects of the machining voltage U and the cathode feed rate v on the side gap Δs and the end gap Δe were investigated. The simulation analysis and experimental results show that both side gap and end gap increase as machining voltage increases but decrease with the increase in cathode feed rate. The model predictions are in good agreement with the experimental results, and the maximum errors of side gap and end gap are 10.6% and 17.7%, respectively. In addition, the effects of machining voltage and cathode feed rate on the surface quality were studied experimentally. Results reveal that surface roughness can be reduced by appropriately decreasing the machining voltage and increasing the cathode feed rate.
Aiming to solve the problems of the low electrolyte flow rate at leading edge and trailing edge and poor uniformity of the end clearance flow field during the electrochemical machining (ECM) of diffuser blades, a gap flow field simulation model was established by designing three liquid-increasing channels at the leading edge and the trailing edge of the cathode. The simulation results indicate that the liquid-increasing hole channel (LIHC) with an outlet area S of 1.5 mm 2 and a distance L from channel center to edge point of 3.2 mm achieves optimal performance. In addition, the experiment results show that the optimized cathode with liquid-increasing hole channel (LIHC) significantly improves the machining efficiency, accuracy and surface quality. Specifically, the feed speed increased from 0.25 mm/min to 0.43 mm/min, the taper decreased from 4.02° to 2.45°, the surface roughness value of blade back reduced from 1.146 µm to 0.802 µm. Moreoever, the roughness of blade basin decreased from 0.961 µm to 0.708 µm, and the roughness of hub reduced from 0.179 µm to 0.119 µm. The results prove the effectiveness of the proposed method, and can be used for ECM of other complex structures with poor flow field uniformity.
Aiming to solve the problems of the low electrolyte flow rate at leading edge and trailing edge and poor uniformity of the end clearance flow field during the electrochemical machining (ECM) of diffuser blades, a gap flow field simulation model was established by designing three liquid-increasing channels at the leading edge and the trailing edge of the cathode. The simulation results indicate that the liquid-increasing hole channel (LIHC) with an outlet area S of 1.5 mm2 and a distance L from channel center to edge point of 3.2 mm achieves optimal performance. In addition, the experiment results show that the optimized cathode with liquid-increasing hole channel (LIHC) significantly improves the machining efficiency, accuracy and surface quality. Specifically, the feed speed increased from 0.25 mm/min to 0.43 mm/min, the taper decreased from 4.02° to 2.45°, the surface roughness value of blade back reduced from 1.146 µm to 0.802 µm. Moreoever, the roughness of blade basin decreased from 0.961 µm to 0.708 µm, and the roughness of hub reduced from 0.179 µm to 0.119 µm. The results prove the effectiveness of the proposed method, and can be used for ECM of other complex structures with poor flow field uniformity.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.