Olmesartan medoxomil (OM) is an antihypertensive drug with poor water solubility and low oral bioavailability (28.6%). Accordingly, this study aimed to formulate and evaluate OM nanosuspension incorporated into oral fast-dissolving films (FDFs) for bioavailability enhancement. OM nanosuspension was prepared by antisolvent-precipitation-ultrasonication method and characterized regarding particle size (122.67 ± 5.03 nm), span value (1.40 ± 0.51), and zeta potential (- 46.56 ± 1.20 mV). Transmission electron microscopy (TEM) of the nanosuspension showed spherical non-aggregating nanoparticles. The nanosuspension was then directly loaded into FDFs by solvent casting technique. A full factorial design (2 × 3) was implemented for optimization of the FDFs using Design-Expert® software. Physical and mechanical characteristics in addition to dissolution profiles of the FDFs were investigated. The optimum formula (FDF1) showed 0.43 ± 0.02 kg/mm tensile strength, 20.50 ± 2.12 s disintegration time, and 87.53 ± 2.50 and 95.99 ± 0.25% OM dissolved after 6 and 10 min, respectively. Accelerated and long-term shelf stability studies confirmed the stability of FDF1. More than 75% OM was dissolved within 10 min from FDF1 compared with 9.80 and 47.80% for films prepared using coarse drug powder and market tablet, respectively. Relative bioavailability of FDF1 compared to market tablet was assessed in healthy human volunteers. The C value increased significantly from 66.62 ± 14.95 to 179.28 ± 23.96 ng/mL for market tablet and FDF1, respectively. Similarly, the AUC value significantly increased from 498.36 ± 217.46 to 1083.67 ± 246.32 ng h/mL for market tablet and FDF1, respectively. Relative bioavailability of FDF1 was 209.28%. The highlighted results verified the effectiveness of OM nanosuspension-loaded FDFs in improving OM bioavailability.
The current study aims to develop niosomal nanocarriers for intranasal delivery of dronedarone hydrochloride to ameliorate its limited bioavailability. Niosomes were prepared by ethanol injection method and optimized using 3² full factorial experimental design. Both Span® type (X1) and Span®: cholesterol ratio (X2) were set as independent variables. Vesicle size (Y1), polydispersity index (Y2), zeta potential (Y3), and entrapment efficiency (Y4) were set as responses. The optimal formula was further incorporated into an ion-sensitive in situ gelling polymer for intranasal delivery. Optimal formula (N7), which is composed of Span® 80: cholesterol (1:1), was of the least vesicle size (121.27 ± 13.31 nm), least polydispersity index (0.43 ± 0.073), highest zeta potential (−22.23 ± 2.84 mV) and highest entrapment efficiency (73.44 ± 2.8%). About 75.86% and 60.29% of dronedarone hydrochloride were released from N7 dispersion and in situ gel, respectively, within 12 h, compared to only 13.3% released from a drug-free suspension. In vivo pharmacokinetic study on male New Zealand rabbits resulted in significantly higher Cmax, AUC0–72, and AUC0–∞ of intranasal niosomal in situ gel compared to oral suspension. Almost twofold amplification of relative bioavailability was obtained after intranasal administration of niosomal in situ gel (195.7%) compared to oral suspension.
The goal of this study was to develop a bilosomal gel formulation to enhance transdermal permeability of dronedarone hyrdrochloride (DRN) which suffers from poor oral absorption and limited bioavailability. To overcome this obstacle, bilosomes were successfully prepared using 23 full-factorial design. Span®40, cholesterol, sodium deoxycholate (bile salt), clove oil (permeability enhancer), and either Tween® 60 or Tween® 80 (edge activator) were used in bilosome preparation by ethanol injection method. In this design, independent variables were X1, edge activator type; X2, edge activator amount (mg); and X3, permeability enhancer concentration (% w/v). Optimal formula (B2) of the highest desirability of (0.776) demonstrated minimum vesicle size (VS) of 312.4 ± 24.42 nm, maximum absolute value of zeta potential (ZP) − 36.17 ± 2.57 mV, maximum entrapment efficiency (EE %) of 80.95 ± 3.01%, maximum deformability Index (DI) of 8.24 ± 1.26 g and maximum drug flux after 12 h (J12) of 21.23 ± 1.54 µg/cm2 h upon ex vivo permeation study. After 12 h, 70.29 ± 6.46% of DRN was released from B2. TEM identification of B2 showed spherical shaped nanosized vesicles which were physically stable for 3 months at different temperatures. B2 was incorporated into carboxymethylcellulose gel base for easiness of dermal application. B2 gel demonstrated good physical properties, non-Newtonian psuedoplastic flow, and enhanced release (57.0 ± 8.68% of DRN compared to only 13.3 ± 1.2% released from drug suspension after 12 h) and enhanced skin permeation. Graphical abstract
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.