In this research, ZnO nanowires doped with Mn2+ and Co2+ ions were synthesized through a facile and inexpensive hydrothermal approach, in which Mn2+ and Co2+ ions successfully substituted Zn2+ in the ZnO crystal lattice without changing the morphology and crystalline structure of ZnO. The atomic percentages of Mn and Co were 6.29% and 1.68%, respectively, in the doped ZnO nanowires. The photocatalytic results showed that Mn-doped and Co-doped ZnO nanowires both exhibited higher photocatalytic activities than undoped ZnO nanowires. Among the doped ZnO nanowires, Co-doped ZnO, which owns a twice active visible-light photocatalytic performance compared to pure ZnO, is considered a more efficient photocatalyst material. The enhancement of its photocatalytic performance originates from the doped metal ions, which enhance the light absorption ability and inhibit the recombination of photo-generated electron-hole pairs as well. The effect of the doped ion types on the morphology, crystal lattice and other properties of ZnO was also investigated.

A series of ZnO-CdS-Ag2S ternary nanostructures with different amounts of Ag2S were prepared using simple and low-cost successive ionic layer adsorption and reaction (SILAR) and a chemical precipitation method. The ZnO nanowires, with a diameter of ∼ 100 nm and a length of ∼ 1 μm, were modified by coating CdS and Ag2S. CdS has a high absorption coefficient and can efficiently match with the energy levels of ZnO, which can enhance the light absorption ability of the nanostructures. In addition, Ag2S with a narrow band gap was used as the main light absorber and played an important role in increasing the light absorption in the visible light region. The photocatalytic activity of the ZnO-CdS-Ag2S ternary nanostructures was investigated using the degradation of methyl orange (MO) in an aqueous solution under visible light. The ZnO-CdS-Ag2S ternary nanostructures were found to be more efficient than ZnO nanowires, ZnO-CdS nanowires, and ZnO-Ag2S nanowires. There is 7.68 times more photocatalytic activity for MO degradation in terms of the rate constant for ZnO-CdS-Ag2S 15-cycle ternary nanostructure compared to the as-grown ZnO. Furthermore, the effect of the amount of Ag2S and CdS on the ZnO surface on the photocatalytic activity was analyzed. The superior photo-absorption properties and photocatalytic performance of the ZnO-CdS-Ag2S ternary nanostructures can be ascribed to the heterostructure, which enhanced the separation of the photo-induced electron-hole pairs. In addition, visible light could be absorbed by ZnO-CdS-Ag2S ternary nanostructures rather than by ZnO.

ZnO nanorod/porous silicon nanowire (ZnO/PSiNW) hybrids with three different structures as highly sensitive NO2 gas sensors were obtained. PSiNWs were first synthesized by metal-assisted chemical etching, and then seeded in three different ways. After that ZnO nanorods were grown on the seeded surface of PSiNWs using a hydrothermal procedure. ZnO/PSiNW hybrids showed excellent gas sensing performance for various NO2 concentrations (5-50 ppm) at room temperature, and the electrical resistance change rate reached as high as 35.1% when responding to 50 ppm NO2. The distinct enhancement was mainly attributed to the faster carrier transportation after combination, the increase in gas sensing areas and the oxygen vacancy (VO) concentration. Moreover, the p-type gas sensing behavior was explained by the gas sensing mechanism and the effect of VO concentration on gas sensing properties was also discussed concerning the photoluminescence (PL) spectra performance.

No abstract

This work presents a new method to improve the field emission (FE) properties of semiconductors decorated with low-cost graphene oxide (GO) nanosheets and trace amounts of noble metal. The Ag/GO/ZnO composite emitter exhibited efficient FE properties with a low turn-on field of 1.4 V μm(-1) and a high field enhancement factor of 7018. The excellent FE properties of the Ag/GO/ZnO composite can be attributed to the tunneling effect of electrons through the heterojunction. The FE properties of the Ag/GO/ZnO composite are slightly better than those of the Ag/ZnO composite which forms an energy well that collects electrons on interfaces when an electric field is applied. This behavior is associated with heterostructures that offer more contact points and protrusions between ZnO nanowire arrays (NWAs) and Ag/GO, which leads to easier electron transfer. High-resolution transmission electron microscopy (HRTEM) and X-ray photoelectron spectroscopy (XPS) were employed to characterise the connection and evolution of the ZnO NWAs and Ag/GO composites.