In the process of industrial production cables and pipes, the precise measurement of the produced product line diameter parameters is very important. In the present paper, we propose an offset compensation diameter measurement system based on analytical geometry and spatial coordinate transformation. The right-angle coordinate system is established in the corresponding planes of the two sets of charge coupling devices and the corresponding laser light source, and the center coordinates of the measured cable are obtained by the analytical geometric method, and the spatial coordinate transformation is used to connect the two coordinate systems to build the offset compensation measurement system. In the actual test (taking θ=45° as an example), considering the overall measurement results of the cylinder standard bar, the overall absolute error is between ± 4 μm without offset, and the relative error is 0~0.05%; and the relative average error (deviation angle is more than 0° and less than 35°) can be maintained at less than 0.7%. The above results demonstrate the feasibility of accurate measurement of this offset-compensated measurement system.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.