The trend towards miniaturization has brought about strong demand for increasingly smaller precision‐molded plastic components. In order to control metering accuracy and homogeneity of the very small quantities of melt in the micro molding process, new micro molding machines that use an injection system comprising a screw extruder and a plunger injection unit have been developed. By use of such injection systems, standard plastic granules can be handled by the screw extruder and melt accuracy can be achieved by the electrically driven injection plunger. The objective of this work is to investigate the effects of the process parameters on the micro molding process and part quality. A series of micro gears were molded using a polyoxymethylene resin in a set of statistically designed experiments. Micro component inspection, characterization, and data analysis work was carried out to study the molded gears. It was found that metering size and holding pressure time are the process parameters that have the most significant effects on part quality, and that the process is also significantly affected by the interaction of these two parameters. There is an optimum metering size range in which the hold pressure can act together with the metering size to properly fill micro mold cavities.
SUMMARYThis paper presents a study of the use of servo-hydraulic systems in the implementation of real-time large-scale structural testing methods in force control such as e ective force testing (EFT) and in displacement control such as real-time pseudodynamic testing (RPsD). Mathematical models for both types of control systems are presented and used to investigate the in uences of servo-systems on the overall system performance. Parameters investigated include the overall system dynamics, nonlinearities of servo-systems, actuator damping, system mass including piston mass, and system response delay. Results of both numerical simulations and experiments showed that many of the in uences of the servo-hydraulic system that signiÿcantly a ect the real-time dynamic tests can be properly compensated through control schemes identiÿed in this paper.
The separation and detection of commonly used preservatives (benzoate, sorbate) and vitamin C by both conventional CE and microchip electrophoresis with capacitively coupled contactless conductivity detection is presented. The separation was optimized by adjusting the pH-value of the buffer and the use of hydroxypropyl-beta-CD (HP-beta-CD) and CTAB as additives. For conventional CE, optimal separation conditions were achieved in a histidine/tartrate buffer at pH 6.5, containing 0.025% HP-beta-CD and 0.1 mM CTAB. LOD ranged from 0.5 to 3 mg/L (S/N = 3) and the RSDs for migration time and peak area were less than 0.1 and 2%, respectively. A considerable reduction of analysis time can be accomplished by using microchip electrophoresis without significant loss in sensitivity under optimal separation conditions. A histidine/tartrate buffer at pH 6.5, incorporating 0.06% HP-beta-CD and 0.25 mM CTAB, gave detection limits ranging between 3 and 10 mg/L and satisfactory reproducibilities of < or =0.4% for the migration time and < or =3.5% for the peak area. The methods developed are useful for the quantitative determination of food additives in real samples such as soft drinks and vitamin C tablets.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.