Adhesive use in fastening is increasing in many industries. Modeling the behavior of adhesives allows joints to be optimized, decreasing costs from over-design and validation testing. Unfortunately, available adhesive material properties provided by manufactures are often insufficient to accurately model and predict behavior under real-world conditions. An adhesive joint in service is often subjected to a combination of mode I (tensile) and mode II (shear) loading. Also, when used in outdoor environments, ambient temperatures can vary from below freezing to over 40°C. This paper describes a project to measure the relevant adhesive material properties at the environmental conditions of interest for two specific adhesives and to use them in subsequent modeling. The needed material properties have been found to be mode I cohesive strength, mode I cohesive toughness, mode II cohesive strength, and mode II cohesive toughness. These properties are measured individually using four tests that isolate each of the material properties by using specimens with distinct geometries and loading conditions. These geometries allow the process zone of the adhesives to be controlled. A large process zone will relate to the cohesive strength, and a small process zone will relate to the cohesive toughness, in either mode I or mode II loading. Since the values of cohesive strength and toughness of the adhesives included in this study are unknown before testing, iterations of each specimen are varied by changing the process zone size to ensure valid properties are measured. Testing is conducted at −30°C, 20°C, and 45°C. In order to conduct this testing a temperature chamber was designed, fabricated, and validated. Commercially available temperature chambers were either too small or prohibitively expensive. The temperature chamber this project created was constructed of laser cut and bent stainless steel sheets with an insulated double-wall construction. Two seals were used at every entry point to maintain an air-tight chamber. A heating and cooling circulator and heat exchanger were used for temperature control. The chamber can heat to 45°C in approximately 15 minutes, and cool to −30°C in approximately 30 minutes.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.