To obtain a mechanistic understanding of occurring processes on oxide surfaces at the atomic level, systematic studies under ultra-high vacuum (UHV) conditions on single crystalline surfaces are commonly used. Usually, the sample preparation protocol for these surfaces includes argon-ion bombardment followed by annealing at elevated temperatures. For reduceable metal oxides, this leads to a significant reduction of the surface. Up to now, the particular role of the remaining argon in the subsequent formation of clean surfaces and the possible incorporation of argon into the crystal lattice as a dopant are typically neglected or remain unclear. This work presents combined, temperature-dependent X-ray photoelectron spectroscopy and a low-energy electron diffraction study under UHV conditions of the bulkassisted reoxidation and restructuring of the rutile TiO 2 (110) single crystal surface after argon-ion bombardment. The formation of an ordered and reoxidized (110)(1 × 1) surface is accompanied by a stepwise desorption of argon from the sample. Moreover, we present a systematic study of the incorporation of argon in the rutile crystal as well as the diffusion and desorption of argon from these samples. By following the temperature-dependent Ar 2p photoelectron spectra, the change of the electronic environment of embedded argon is elucidated, demonstrating the interaction with reduced Ti cations. Hence, residual argon (in case of Ar + ) possibly acts as a strong oxidant or induces significant lattice distortions. Our results show that residual argon from the sample preparation is an important hidden dopant and needs to be considered in the evaluation of typical studies on oxide surfaces under UHV conditions in future work.

Rutile TiO2 is an important model system for understanding the adsorption and conversion of molecules on transition metal oxide catalysts. In the last decades, point defects, such as oxygen vacancies and Ti3+ interstitials, exhibited an important influence on the reaction of oxygen and oxygen-containing molecules on titania surfaces. In brief, partially reduced TiO2 containing a significant amount of Ti3+ is often more active for the conversion of such molecules. In this study, we investigate an even higher reduced surface prepared by argon ion bombardment of a rutile TiO2 (110) single crystal. By X-ray photoelectron spectroscopy we show that, besides Ti4+, this surface is almost equally dominated by Ti3+ and Ti2+. To probe the reactivity of these highly reduced surfaces, we have adsorbed two different classes of oxygen-containing molecules and utilized temperature programmed reaction spectroscopy to investigate the conversion. While alcohols (in this case methanol) already show a defect-dependent partial conversion in a deoxygenation reaction on the (stochiometric or slightly reduced) rutile TiO2 (110) surface, ketones (e.g. acetone) are usually not converted on the rutile TiO2 (110) surface independent on the bulk defect density. Here, we present a nearly full conversion for both molecules via deoxygenation reactions and reductive C–C coupling, forming different hydrocarbons at different temperatures between 375 K and 640 K on the sputtered Ti2+ rich surface.

A fundamental reaction in industries for producing aldehydes and ketones is the partial oxidation of alcohols. As a model reaction, we investigated the photo-oxidation of 2-propanol on rutile titania, which is a promising chemically nontoxic photocatalyst. Photochemical infrared reflection absorption spectroscopy (PC-IRRAS) was used to study the reaction on powder catalysts in the liquid phase (neat liquid and dissolved in dichloromethane). We compare these results with polarized Fourier transform (FT)-IRRAS and temperature-programmed desorption (TPD) experiments on rutile TiO2(110) single crystals in ultrahigh vacuum (UHV). Our in situ liquid-phase experiments showed that 2-propanol converts into acetone on rutile powders, which is in accordance with previous ex situ studies. Mass transport limitations are the key to avoid total oxidation. However, the yield of acetone is limited. We identified water formed as a byproduct and suspected that water might block the active sites. To elucidate possible reaction mechanisms, further experiments were performed on rutile TiO2(110) single crystals in the presence and absence of oxygen and UV irradiation under UHV conditions. Here, we obtained further insights into the elementary steps of the different 2-propanol reactions. We demonstrated that acetone desorbs from a diolate species, which forms in the presence of oxygen under UV irradiation at temperatures around 200 K. Furthermore, propane was identified for the first time as a new thermally activated deoxygenation product besides the simultaneously formed, formally reported, propene. Propene formation is quenched by UV irradiation. Active site blocking by water is confirmed by TPD and polarized FT-IRRAS measurements.

The photochemical conversion of organic compounds on tailored transition metal oxide surfaces by (UV) irradiation has found wide applications ranging from the production of chemicals to the degradation of organic...

The reaction of Eu2O3 with fuming nitric acid, trifluormethanesulfonic acid, and its anhydride in torch-sealed glass ampoules at 120 °C gave the europium compound (NO)5[Eu(O3SCF3)8] (orthorhombic, Fddd, Z = 16, a = 1932.69(4), b = 2878.44(7), c = 2955.12(7) pm, V = 16439.7(7) Å(3)). The compound exhibits the [Eu(O3SCF3)8](5-) anion showing for the first time a lanthanide ion that is exclusively coordinated by eight triflate anions. The anion has been further investigated by DFT calculations, which also allowed clear assignment of the vibrational spectra. Moreover, magnetochemical and luminescence measurements gave additional insight into the properties of this complex. The luminescence spectra revealed that the Eu(3+) ions are in a pseudo D4d symmetric environment.