Zero valent iron (ZVI) nanoparticles are versatile in their ability to remove a wide variety of water contaminants, and ZVI-based bimetallic nanoparticles show increased reactivity above that of ZVI alone. ZVI nanoparticles degrade contaminants through the reactive species (e.g., OH*, H(2(g)), H(2)O(2)) that are produced during iron oxidation. Measurement and modeling of aqueous ZVI nanoparticle oxidation kinetics are therefore necessary to optimize nanoparticle design. Stabilized ZVI and iron-nickel nanoparticles of approximately 150 nm in diameter were synthesized through solution chemistry, and nanoparticle oxidation kinetics were determined via measured mass change using a quartz crystal microbalance (QCM). Under flowing aerated water, ZVI nanoparticles had an initial exponential growth behavior indicating surface-dominated oxidation controlled by migration of species (H(2)O and O(2)) to the surface. A region of logarithmic growth followed the exponential growth which, based on the Mott-Cabrera model of thin oxide film growth, suggests a reaction dominated by movement of species (e.g., iron cations and oxygen anions) through the oxide layer. The presence of ethanol or a nickel shell on the ZVI nanoparticles delayed the onset of iron oxidation and reduced the extent of oxidation. In oxygenated water, ZVI nanoparticles oxidized primarily to the iron oxide-hydroxide lepidocrocite.

Polymer-derived ceramic composites are being investigated as environmental barrier coatings to protect stainless steel from oxidation and carburization. Coatings have been produced using poly(hydridomethylsiloxane) as a preceramic polymer and titanium disilicide as an expansion agent. Processing parameters have been optimized and a relationship has been derived to predict the final coating thickness based on slurry viscosity and dip coating withdrawal speed. Microstructural analysis reveals a composite coating of oxidized filler particles in a silica matrix. A diffusion layer is visible at the coating-steel interface, indicating good bonding. The optimized coatings are B18 lm thick, and have some residual porosity and a density of 2.56 g/cm 3 .

No abstract