Proton transfer across single-layer graphene proceeds with large computed energy barriers and is therefore thought to be unfavourable at room temperature unless nanoscale holes or dopants are introduced, or a potential bias is applied. Here we subject single-layer graphene supported on fused silica to cycles of high and low pH, and show that protons transfer reversibly from the aqueous phase through the graphene to the other side where they undergo acid–base chemistry with the silica hydroxyl groups. After ruling out diffusion through macroscopic pinholes, the protons are found to transfer through rare, naturally occurring atomic defects. Computer simulations reveal low energy barriers of 0.61–0.75 eV for aqueous proton transfer across hydroxyl-terminated atomic defects that participate in a Grotthuss-type relay, while pyrylium-like ether terminations shut down proton exchange. Unfavourable energy barriers to helium and hydrogen transfer indicate the process is selective for aqueous protons.

This Article reports measurements of the intra- and intermolecular ordering of tight-binding octylphosphonate ligands on the surface of colloidal CdSe quantum dots (QDs) within solid state films, and the dependence of this order on the size of the QDs. The order of the organic ligands, as probed by vibrational sum frequency generation (SFG) spectroscopy, decreases as the radius of the QDs decreases; this decrease is correlated with a decrease in the order of underlying Cd(2+), as detected by X-ray photoelectron spectroscopy (XPS) line width measurements, for radii of the QDs, R > 2.4 nm, and is independent of the disorder of the Cd(2+) for R < 2.4 nm. We believe that, for R < 2.4, the decreasing order of the ligands with decreasing size is due to an increase in the curvature of the QD surfaces. Disorder in the Cd(2+) results from the presence of a shell of Cd(2+)-surfactant complexes that form during synthesis, so this work demonstrates the possibility for chemical control over molecular order within films of colloidal QDs by changing the surfactant mixture.

Electrostatics and counterions play important roles in many supramolecular processes, including surfactant adsorption and aggregation at interfaces. Here, we assess their influence on how the common surfactant cetyltrimethylammonium (CTA) interacts with fused silica/aqueous interfaces by determining thermodynamic, kinetic, and electrostatic parameters for CTA adsorption across a range of NaCl concentrations (10-500 mM NaCl) using second harmonic generation (SHG). Using vibrational sum frequency generation (SFG), we demonstrate that vibrationally resonant contributions and nonresonant background contributions to the SFG signal intensity that depend on the interfacial potential can be quantified simultaneously during the adsorption process, which provides insight into the nonequilibrium dynamics of CTA adsorption. By analyzing the adsorption free energies as a function of interfacial potential at these four salt concentrations, the charge density per adsorbate is determined, indicating that CTA coadsorbs with counterions at a ratio of approximately 4 to 3 (i.e., 4 CTA(+) ions for every 3 Cl(-) ion). The chemical (i.e., non-Coulombic) portion of the free energy is found to dominate the overall free energy of adsorption, indicating that CTA adsorption at these ionic strengths is primarily driven by the favorable hydrophobic interactions between interdigitated surfactant hydrocarbon chains in the adsorbed aggregate. By applying Gouy-Chapman-Stern theory to our data, an average charge density of 2.8(3) x 10(13) charges/cm(2), which corresponds to 0.7 to 1.7 molecules/nm(2), was obtained for the four NaCl concentrations.

Fluid/solid interfaces containing single-layer graphene are important in the areas of chemistry, physics, biology, and materials science, yet this environment is difficult to access with experimental methods, especially under flow conditions and in a label-free manner. Herein, we demonstrate the use of second harmonic generation to quantify the interfacial free energy at the fused silica/single-layer graphene/water interface at pH 7 and under conditions of flowing aqueous electrolyte solutions ranging in NaCl concentrations from 10(-4) to 10(-1) M. Our analysis reveals that single-layer graphene reduces the interfacial free energy density of the fused silica/water interface by a factor of up to 7, which is substantial given that many interfacial processes, including those that are electrochemical in nature, are exponentially sensitive to interfacial free energy density.

Abstract. Secondary organic aerosol (SOA) particle formation ranks among the least understood chemical processes in the atmosphere, rooted in part in the lack of knowledge about chemical composition and structure at the particle surface, and little availability of reference compounds needed for benchmarking and chemical identification in pure and homogenous form. Here, we synthesize and characterize SOA particle constituents consisting of the isoprene oxidation products α-, δ-, and cis- and trans-β-IEPOX (isoprene epoxide), as well as syn- and anti-2-methyltetraol. Paying particular attention to their phase state (condensed vs. vapor), we carry out a surface-specific and orientationally selective chemical analysis by vibrational sum frequency generation (SFG) spectroscopy of these compounds in contact with a fused silica window. Comparison to the vibrational SFG spectra of synthetic isoprene-derived SOA particle material prepared at the Harvard Environmental Chamber yields a plausible match with trans-β-IEPOX, suggesting it is an abundant species on their surfaces, while the other species studied here, if present, appear to be SFG inactive and thus likely to be localized in a centrosymmetric environment, e.g., the particle bulk. No match is found for authentic SOA particle material collected at the site of the Amazonian Aerosol Characterization Experiment (AMAZE-08) with the surface SFG spectra of the compounds surveyed here, yet we cannot rule out this mismatch being attributable to differences in molecular orientation. The implications of our findings for SOA formation are discussed in the context of condensational particle growth and reactivity.