No abstract

A fluorescence resonance energy transfer pair consisting of a colloidal quantum dot donor and multiple organic fluorophores as acceptors is reported and the photophysics of the system is characterized. Most nanoparticle-based biosensors reported so far use the detection of specific changes of the donor/acceptor distance under the influence of analyte binding. Our nanoparticle design on the other hand leads to sensors that detect spectral changes of the acceptor (under the influence of analyte binding) at fixed donor/acceptor distance by the introduction of the acceptor into the polymer coating. This approach allows for short acceptor-donor separation and thus for high-energy transfer efficiencies. Advantageously, the binding properties of the hydrophilic polymer coating further allows for addition of poly(ethylene glycol) shells for improved colloidal stability.

The 3-processing of the extremities of viral DNA is the first of two reactions catalyzed by HIV-1 integrase (IN). High order IN multimers (tetramers) are required for complete integration, but it remains unclear which oligomer is responsible for the 3-processing reaction. Moreover, IN tends to aggregate, and it is unknown whether the polymerization or aggregation of this enzyme on DNA is detrimental or beneficial for activity. We have developed a fluorescence assay based on anisotropy for monitoring release of the terminal dinucleotide product in realtime. Because the initial anisotropy value obtained after DNA binding and before catalysis depends on the fractional saturation of DNA sites and the size of IN⅐DNA complexes, this approach can be used to study the relationship between activity and binding/multimerization parameters in the same assay. By increasing the IN:DNA ratio, we found that the anisotropy increased but the 3-processing activity displayed a characteristic bell-shaped behavior. The anisotropy values obtained in the first phase were predictive of subsequent activity and accounted for the number of complexes. Interestingly, activity peaked and then decreased in the second phase, whereas anisotropy continued to increase. Time-resolved fluorescence anisotropy studies showed that the most competent form for catalysis corresponds to a dimer bound to one viral DNA end, whereas higher order complexes such as aggregates predominate during the second phase when activity drops off. We conclude that a single IN dimer at each extremity of viral DNA molecules is required for 3-processing, with a dimer of dimers responsible for the subsequent full integration.The integration of a DNA copy of the HIV-1 2 genome into the host genome is a crucial step in the life cycle of the retrovirus. Integrase (IN) is responsible for the two consecutive reactions that constitute the overall integration process. The first of these two reactions is 3Ј-processing, which involves cleavage of the 3Ј-terminal GT dinucleotide at each extremity of the viral DNA. The hydroxyl groups of newly recessed 3Ј-ends are then used in the second reaction, strand transfer, for the covalent joining of viral and target DNAs, resulting in full-site integration. IN is sufficient for catalysis of the 3Ј-processing reaction in vitro, using short-length oligodeoxynucleotides (ODNs) that mimic one viral long terminal repeat (LTR) in the presence of the metallic cofactor Mg 2ϩ . This reaction generates two products: the viral DNA containing the recessed extremity and the GT dinucleotide. One of the two products, the processed viral DNA, as well as the target DNA serve as substrates for the subsequent joining reaction.IN belongs to the superfamily of polynucleotidyl transferases. Its catalytic core domain contains a triad of acidic residues constituting the D,D-35-E motif, which is strictly required for catalysis. The catalytic core establishes specific contacts with the viral DNA and, together with the C-terminal domain, is involved in DNA binding (1-4). ...

Self-assembly properties of HIV-1 integrase were investigated by time-resolved fluorescence anisotropy using tryptophanyl residues as a probe. From simulation analyses, we show that suitable photon counting leads to an accurate determination of long rotational correlation times in the range of 20-80 ns, permitting the distinction of the monomer, dimer, and tetramer from higher oligomeric forms of integrase. The accuracy of correlation times higher than 100 ns is too low to distinguish the octamer from other larger species. The oligomeric states of the widely used detergent-solubilized integrase were then studied in solution under varying parameters known to influence the activity. In the micromolar range, integrase exists as high-order multimers such as an octamer and/or aggregates and a well-defined tetramer, at 25 and 35 degrees C, respectively. However, integrase is monomeric at catalytically active concentrations (in the sub-micromolar range). Detergents (NP-40 and CHAPS) and divalent cation cofactors (Mg(2+) and Mn(2+)) have a clear dissociative effect on the high multimeric forms of integrase. In addition, we observed that Mg(2+) and Mn(2+) have different effects on both the oligomeric state and the conformation of the monomer. This could explain in part why these two metal cations are not equivalent in terms of catalytic activity in vitro. In contrast, addition of Zn(2+) stimulates dimerization. Interestingly, this role of Zn(2+) in the multimerization process was evident only in the presence of Mg(2+) which by itself does not induce oligomerization. Finally, it is highly suggested that the presence of detergent during the purification procedure plays a negative role in the proper self-assembly of integrase. Accordingly, the accompanying paper [Leh, H., et al. (2000) Biochemistry 39, 9285-9294] shows that a detergent-free integrase preparation has self-assembly and catalytic properties different from those of the detergent-solubilized enzyme.

The relationship between Mg(2+)-dependent activity and the self-assembly state of HIV-1 integrase was investigated using different protein preparations. The first preparations, IN(CHAPS) and IN(dial), were purified in the presence of detergent, but in the case of IN(dial), the detergent was removed during a final dialysis. The third preparation, IN(zn), was purified without any detergent. The three preparations displayed comparable Mn(2+)-dependent activities. In contrast, the Mg(2+)-dependent activity that reflects a more realistic view of the physiological activity strongly depended on the preparation. IN(CHAPS) was not capable of using Mg(2+) as a cofactor, whereas IN(zn) was highly active under the same conditions. In the accompanying paper [Deprez, E., et al. (2000) Biochemistry 39, 9275-9284], we used time-resolved fluorescence anisotropy to demonstrate that IN(CHAPS) was monomeric at the concentration of enzymatic assays. Here, we show that IN(zn) was homogeneously tetrameric under similar conditions. Moreover, IN(dial) that exhibited an intermediary Mg(2+)-dependent activity existed in a monomer-multimer equilibrium. The level of Mg(2+)- but not Mn(2+)-dependent activity of IN(dial) was altered by addition of detergent which plays a detrimental role in the maintenance of the oligomeric organization. Our results indicate that the ability of integrase to use Mg(2+) as a cofactor is related to its self-assembly state in solution, whereas Mn(2+)-dependent activity is not. Finally, the oligomeric IN(zn) was capable of binding efficiently to DNA regardless of the cationic cofactor, whereas the monomeric IN(CHAPS) strictly required Mn(2+). Thus, we propose that a specific conformation of integrase is a prerequisite for its binding to DNA in the presence of Mg(2+).

As a step toward the elucidation of the mechanistic pathways governing the known bioactivity of polyoxometalates (POMs), two representative molecules of this class of chemicals, the wheel-shaped [NaP(5)W(30)O(110)]14- (P(5)W(30)) and the Keggin-type anion [H(2)W(12)O(40)]6- (H(2)W(12)), are shown, by two independent techniques, to interact with the fatty-acid-free human serum albumin (HSA). The excited-state lifetime of the single tryptophan molecule of this protein is dramatically decreased by the binding. The quenching mechanism is found to constitute the first example of energy transfer between HSA and POMs. Such molecular recognition is believed to be a key step for subsequent evolution of the systems. Circular dichroism (CD) was used to assess the structural effects of POM binding on HSA and to confirm the interaction revealed by fluorescence studies. CD experiments showed that the two POMs have different effects on the secondary structure of the protein. Binding P(5)W(30) partially unfolds the protein whereas H(2)W(12) has no remarkable effect on the structure of the protein.

Self-assembly of HIV-1 integrase (IN) in solution has been studied previously by time-resolved fluorescence, using tryptophan anisotropy decay. This approach provides information on the size of macromolecules via the determination of rotational correlation times ( ). We have shown that, at submicromolar concentration, IN is characterized by a long rotational correlation time ( 20°C ‫؍‬ 90 -100 ns) corresponding to a high-order oligomeric form, likely a tetramer. In the present work, we investigated the self-assembly properties of the DNA-bound IN by using three independent fluorophores. Under enzymatic assay conditions (10 ؊7 M IN, 2 ؋ 10 ؊8 M DNA), using either fluorescein-labeled or fluorescent guanosine analog-containing oligonucleotides that mimic a viral end long terminal repeat sequence, we found that the DNA- I ntegration of a DNA copy of the HIV-1 genome into the host genome is a critical step of the retrovirus life cycle. Integration is a multistep process including 3Ј processing, strand transfer, and DNA repair. Integrase (IN) is responsible for 3Ј processing and strand transfer and is sufficient to catalyze these two reactions in vitro, using short-length oligonucleotides (ODNs) that mimic the viral end long terminal repeat sequences. The repair step most likely is performed by a host system. IN is a member of the superfamily of polynucleotidyl transferases, and its catalytic core domain contains a triad of acidic residues that constitute the so-called D,D-35-E motif. This motif is strictly required for catalysis (1, 2) and is involved in the coordination of the metal cation cofactor (3, 4). Catalysis can be performed efficiently in vitro by using either Mn 2ϩ or Mg 2ϩ , but several investigations suggest that these two divalent cations have different effects on the reaction specificity. Specific protein-DNA contacts occur preferentially in the presence of Mg 2ϩ (5), and more nonspecific cleavage is detected in the presence of Mn 2ϩ (6). The transfer pattern on the target DNA also depends on the nature of the cation (7). Consequently, the efficiency of inhibitors can be different by using either Mg 2ϩ or Mn 2ϩ in assays (8). In each case, the Mg 2ϩ -dependent activity may be more reliable because it is more physiologically relevant.Specific recognition between IN and the substrate viral DNA is a prerequisite for the cleavage of two nucleotides at the 3Ј end of the viral DNA. The catalytic core domain establishes specific contacts with the viral DNA, and it has been determined that the terminal 13-base region of the long terminal repeat plays a significant role for Mg 2ϩ -dependent processing in terms of specificity (5, 9). The C-terminal domain also mediates viral DNA-IN interactions, but in a nonspecific fashion, and more likely contributes to complex stabilization (10-12). Furthermore, it is strongly believed that self-association of IN plays a key role in governing the enzyme function (13-16). Recently, we have shown that the capability of IN to use Mg 2ϩ is related to the protein self-association ...

The multifunctional DNA repair enzymes apurinic͞apyrimidinic (AP) endonucleases cleave DNA at AP sites and 3 -blocking moieties generated by DNA glycosylases in the base excision repair pathway. Alternatively, in the nucleotide incision repair (NIR) pathway, the same AP endonucleases incise DNA 5 of a number of oxidatively damaged bases. At present, the physiological relevance of latter function remains unclear. Here, we report genetic dissection of AP endonuclease functions in base excision repair and NIR pathways. Three mutants of Escherichia coli endonuclease IV (Nfo), carrying amino acid substitutions H69A, H109A, and G149D have been isolated. All mutants were proficient in the AP endonuclease and 3 -repair diesterase activities but deficient in the NIR. Analysis of metal content reveals that all three mutant proteins have lost one of their intrinsic zinc atoms. Expression of the nfo mutants in a repair-deficient strain of E. coli complemented its hypersensitivity to alkylation but not to oxidative DNA damage. The differential drug sensitivity of the mutants suggests that the NIR pathway removes lethal DNA lesions generated by oxidizing agents. To address the physiological relevance of the NIR pathway in human cells, we used the fluorescence quenching mechanism of molecular beacons. We show that in living cells a major human AP endonuclease, Ape1, incises DNA containing ␣-anomeric 2 -deoxyadenosine, indicating that the intracellular environment supports NIR activity. Our data establish that NIR is a distinct and separable function of AP endonucleases essential for handling lethal oxidative DNA lesions. apurinic͞apyrimidinic endonuclease ͉ oxidative DNA damage ͉ tert-butyl hydroperoxide ͉ 3Ј-blocking groups ͉ ␣-anomeric 2Ј-deoxyadenosine