Large-eddy simulations (LES) are used to investigate the effect of stable stratification on rural-to-urban roughness transitions. Smooth-wall turbulent boundary layers are subjected to a generic urban roughness consisting of cubes in an in-line arrangement. Two line sources of pollutant are added to investigate the effect on pollutant dispersion. Firstly, the LES method is validated with data from wind-tunnel experiments on fully-developed flow over cubical roughness. Good agreement is found for the vertical profiles of the mean streamwise velocity component and mean Reynolds stress. Subsequently, roughness transition simulations are done for both neutral and stable conditions. Results are compared with fully-developed simulations with conventional double-periodic boundary conditions. In stable conditions, at the end of the domain the streamwise velocity component has not yet reached the fully-developed state even though the surface forces are nearly constant. Moreover, the internal boundary layer is shallower than in the neutral case. Furthermore, an investigation of the turbulence kinetic energy budget shows that the buoyancy destruction term is reduced in the internal boundary layer, above which it is equal to the undisturbed (smooth wall) value. In addition, in stable conditions pollutants emitted above the urban canopy enter the canopy farther downstream due to decreased vertical mixing. Pollutants emitted below the top of the urban canopy are 85 % higher in concentration in stable conditions mostly due to decreased advection. If this is taken into account concentrations remain 17 % greater in stable conditions due to less rapid internal boundary-layer growth. Finally, it

Both large-eddy simulations (LES) and water-tunnel experiments, using simultaneous stereoscopic particle image velocimetry and laser-induced fluorescence, have been used to investigate pollutant dispersion mechanisms in regions where the surface changes from rural to urban roughness. The urban roughness was characterized by an array of rectangular obstacles in an in-line arrangement. The streamwise length scale of the roughness was kept constant, while the spanwise length scale was varied by varying the obstacle aspect ratio l/ h between 1 and 8, where l is the spanwise dimension of the obstacles and h is the height of the obstacles. Additionally, the case of two-dimensional roughness (riblets) was considered in LES. A smooth-wall turbulent boundary layer of depth 10h was used as the approaching flow, and a line source of passive tracer was placed 2h upstream of the urban canopy. The experimental and numerical results show good agreement, while minor discrepancies are readily explained. It is found that for l/ h = 2 the drag induced by the urban canopy is largest of all considered cases, and is caused by a large-scale secondary flow. In addition, due to the roughness transition the vertical advective pollutant flux is the main ventilation mechanism in the first three streets. Furthermore, by means of linear stochastic estimation the mean flow structure is identified that is responsible for street-canyon ventilation for the sixth street and onwards. Moreover, it is shown that the vertical length scale of this structure increases with increasing aspect ratio of the obstacles in the canopy, while the streamwise length scale does not show a similar trend.

h i g h l i g h t s g r a p h i c a l a b s t r a c tThe combined effect of shear and buoyancy on dispersion behind a fence is examined. Stable turbulent boundary layers up to Ri grad ¼ 0.2 are generated by a recycle method. The fence affects concentrations up to at least 100 obstacle heights downstream.The decay of maximum velocity and temperature deficit is independent of stability.The decay in maximum concentration excess decreases appreciably with stability. a b s t r a c tPredicting pollutant dispersion in urban environments requires accurate treatment of obstacle geometry, inflow turbulence and temperature differences. This paper considers both the influence of thermal stratification and the presence of a single obstacle on pollutant dispersion in turbulent boundary layers (TBLs). Turbulent flow over a fence with line sources of pollutant in its vicinity is simulated by means of Large-Eddy Simulations. Separate 'driver' simulations are done to generate the inflow TBL for several levels of stratification. Using these inflow TBLs the flow development and pollutant dispersion behind the fence, up to 100 fence heights, h, is investigated. It is shown that the decay of velocity and temperature deficit is independent of stability, while the decay of Reynolds stress and concentration excess decreases with increasing stability. For neutral cases the influence of the obstacle is gone after approximately 75h, while for stable cases near the ground the flow is still accelerated compared to the undisturbed case. The fence does cause a local reduction of stratification and thereby increased pollutant dispersion. However, neglecting the effect of buoyancy results in an underestimation of pollutant concentration by a factor 2.5 at 75h downstream of the emission source for the most stable case.

No abstract

The CONFIDENCE dissemination workshop “Coping with uncertainties for improved modelling and decision making in nuclear emergencies” was held in December 2–5, 2019 (Bratislava, Slovak Republic). About 90 scientists and decision makers attended the workshop. The dissemination workshop allowed the presentation of the CONFIDENCE project results, demonstration of the applicability of the developed methods and tools in interactive discussion sessions and the collection of feedback from the participants. The results were disseminated not only in the form of presentations and posters but also through interactive workshops where all participants were involved in round table working groups. A fictive accidental release scenario taking place at a nuclear power plant was developed and used by each work package in the workshop to provide the basis for interactive sessions and discussions.