12-Silicotungstic acid, a heteropoly acid (HPA) -was incorporated into phosphoric acid (PA) doped polybenzimidazole (PBI) membrane that exhibited strong mechanical stability, excellent proton conductivity, and can be used for high temperature proton exchange membrane fuel cells (PEMFCs). At 160 • C, an electrochemical impedance spectroscopy (EIS) fitting of the fuel cells data showed the membrane electrode assemblies (MEAs) made of PBI/20%HPA/PA had three times lower ohmic resistance (0.057 ± 0.002 Ohm * cm 2 ) as compared to the control reference of PBI/PA (0.160 Ohm * cm 2 ). In addition, the ohmic resistance of the composite MEA remained unchanged while the charge transfer resistance decreased after 313 hours conditioning. Fourier transform infrared spectroscopy (FTIR), magic angle spinning -nuclear magnetic resonance (MAS-NMR), and thermogravimetric analysis (TGA) showed 12-silicotungstic acid inhibits water from escaping the membrane at elevated temperatures and adds more acid sites, providing additional paths for proton transport. Scanning electron microscope (SEM), transmission electron microscopy (TEM), and small angle X-ray scattering (SAXS) were used to confirm the structure and morphology of PBI/20%HPA/PA membrane prior making the MEAs. Fuel cell technologies have the potential to reduce our dependence on fossil fuels and to reduce associated emissions of pollutants as the global population continues to grow. Polymer electrolyte membrane fuel cells (PEMFCs) have the advantage of being fully scalable for stationary power generation than other types of fuel cells. PEMFCs have outstanding power density, rapid start-up, and high efficiency. 1In addition, the operation of PEMFCs is straightforward and does not generate any additional pollutants. Despite several advantages, current PEMFCs are not yet widely used or commercialized, because they remain too expensive, do not have enough durability, and require very pure hydrogen as a fuel.2 At the moment, PEMFCs generally operate below 100• C due to the need to fully humidify commonly used perfluorosulfonic acid electrolytes such as Nafion. At low operating temperatures, a small concentration of CO or SO 2 impurities in the fuel could poison the catalysts and lower the fuel cell performance. Therefore, current PEMFCs require high purity hydrogen that can only be cost-effectively produced from natural gas at this time. Furthermore, the humidification of fuel and oxidant in low temperature PEMFCs requires a complicated humidification system. These technical challenges can be addressed by increasing operating temperatures above 120• C. High temperature operation is a promising way to improve PEMFC performance; it has been shown that higher operating temperatures would increase chemical kinetics at the anode and dramatically enhance the electrode tolerance to fuel impurities, which allows for the use of lower-cost hydrogen.3 In addition, fuel cell operation above 120• C can tolerate up to 1% CO and 10 ppm SO 2 . Operating at elevated temperatures would also provid...
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.