No abstract

Hydraulic bushings, which are often employed in vehicle suspension systems, exhibit significant excitation-dependent properties. However, previous analyses were mainly based on the linear system theory. To overcome this void, nonlinear characteristics of common hydraulic bushing configurations are examined in this article, with focus on the component properties as excited by sinusoidal or step displacements of various amplitudes. First, a nonlinear model for a laboratory prototype with a long passage and a short passage (in parallel) is developed using a lumped-parameter approach. Then the system parameters and nonlinearities are identified using experimental and computational methods, with an emphasis on characterization of the flow passage resistances. Steady-state harmonic and transient step experiments are conducted on the prototype, and the dynamic pressures inside two fluid chambers and the force transmitted to the base are measured. Numerical solution of the nonlinear model shows that the proposed model predicts both steady-state sinusoidal responses and transient responses well for single-passage and dual-passage configurations; significant improvement over a corresponding linear model is observed. Finally, approximate analytical and semi-analytical solutions of the nonlinear model are obtained by using the harmonic balance method.

No abstract

This paper proposes a new analytical model for a thin cylindrical shell that utilizes a homogeneous cardboard liner to increase modal damping. Such cardboard liners are frequently used as noise and vibration control devices for cylindrical shell-like structures in automotive drive shafts. However, most prior studies on such lined structures have only investigated the associated damping mechanisms in an empirical manner. Only finite element models and experimental methods have been previously used for characterization, whereas no analytical studies have addressed sliding friction interaction at the shell-liner interface. The proposed theory, as an extension of a prior experimental study, uses the Rayleigh-Ritz method and incorporates material structural damping along with frequencydependent viscous and Coulomb interfacial damping formulations for the shell-liner interaction. Experimental validation of the proposed model, using a thin cylindrical shell with three different cardboard liner thicknesses, is provided to validate the new model, and to characterize the damping parameters. Finally, the model is used to investigate the effect of the liner and the damping parameters on the modal attenuation of the shell vibration, in particular for the higher-order coupled shell modes.

No abstract