The structure of IrO2 during the oxygen evolution reaction (OER) was studied by operando X-ray absorption spectroscopy (XAS) at the Ir L3-edge to gain insight into the processes that occur during the electrocatalytic reaction at the anode during water electrolysis. For this purpose, calcined and uncalcined IrO2 nanoparticles were tested in an operando spectroelectrochemical cell. In situ XAS under different applied potentials uncovered strong structural changes when changing the potential. Modulation excitation spectroscopy combined with XAS enhanced the information on the dynamic changes significantly. Principal component analysis (PCA) of the resulting spectra as well as FEFF9 calculations uncovered that both the Ir L3-edge energy and the white line intensity changed due to the formation of oxygen vacancies and lower oxidation state of iridium at higher potentials, respectively. The deconvoluted spectra and their components lead to two different OER modes. It was observed that at higher OER potentials, the well-known OER mechanisms need to be modified, which is also associated with the stabilization of the catalyst, as confirmed by in situ inductively coupled plasma mass spectrometry (ICP-MS). At these elevated OER potentials above 1.5 V, stronger Ir–Ir interactions were observed. They were more dominant in the calcined IrO2 samples than in the uncalcined ones. The stronger Ir–Ir interaction upon vacancy formation is also supported by theoretical studies. We propose that this may be a crucial factor in the increased dissolution stability of the IrO2 catalyst after calcination. The results presented here provide additional insights into the OER in acid media and demonstrate a powerful technique for quantifying the differences in mechanisms on different OER electrocatalysts. Furthermore, insights into the OER at a fundamental level are provided, which will contribute to further understanding of the reaction mechanisms in water electrolysis.
The increasing scarcity of iridium (Ir) and its rutile-type oxide (IrO 2 ), the current state-of-the-art oxygen evolution reaction (OER) catalysts, is driving the transition toward the use of mixed Ir oxides with a highly active yet inexpensive metal (Ir x M 1−x O 2 ). Ruthenium (Ru) has been commonly employed due to its high OER activity although its electrochemical stability in Ir-Ru mixed oxide nanoparticles (Ir x Ru 1−x O 2 NPs), especially at high relative contents, is rarely evaluated for long-term application as water electrolyzers. In this work, we bridge the knowledge gap by performing a thorough study on the composition-and phase-dependent stability of welldefined Ir x Ru 1−x O 2 NPs prepared by flame spray pyrolysis under dynamic operating conditions. As-prepared NPs (Ir x Ru 1−x O y ) present an amorphous coral-like structure with a hydrous Ir-Ru oxide phase, which upon post-synthetic thermal treatment fully converts to a rutile-type structure followed by a selective Ir enrichment at the NP topmost surface. It was demonstrated that Ir incorporation into a RuO 2 matrix drastically reduced Ru dissolution by ca. 10-fold at the expense of worsening Ir inherent stability, regardless of the oxide phase present. Hydrous Ir x Ru 1−x O y NPs, however, were shown to be 1000-fold less stable than rutile-type Ir x Ru 1−x O 2 , where the severe Ru leaching yielded a fast convergence toward the activity of monometallic hydrous IrO y . For rutiletype Ir x Ru 1−x O 2 , the sequential start-up/shut-down OER protocol employed revealed a steady-state dissolution for both Ir and Ru, as well as the key role of surface Ru species in OER activity: minimal Ru surface losses (<1 at. %) yielded OER activities for tested Ir 0.2 Ru 0.8 O 2 equivalent to those of untested Ir 0.8 Ru 0.2 O 2 . Ir enrichment at the NP topmost surface, which mitigates selective subsurface Ru dissolution, is identified as the origin of the NP stabilization. These results suggest Ru-rich Ir x Ru 1−x O 2 NPs to be viable electrocatalysts for long-term water electrolysis, with significant repercussions in cost reduction.
Targeted improvement of the low efficiency of water oxidation during the oxygen evolution reaction (OER) is severely hindered by insufficient knowledge of the electrocatalytic mechanism on heterogeneous surfaces. We chose LiMn2O4 as a model system for mechanistic investigations as it shares the cubane structure with the active site of photosystem II and the valence of Mn3.5+ with the dark‐stable S1 state in the mechanism of natural photosynthesis. The investigated LiMn2O4 nanoparticles are electrochemically stable in NaOH electrolytes and show respectable activity in any of the main metrics. At low overpotential, the key mechanistic parameters of Tafel slope, Nernst slope, and reaction order have constant values on the RHE scale of 62(1) mV dec−1, 1(1) mV pH−1, −0.04(2), respectively. These values are interpreted in the context of the well‐studied mechanism of natural photosynthesis. The uncovered difference in the reaction sequence is important for the design of efficient bio‐inspired electrocatalysts.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.