No abstract

A simple and rapid analytical method was developed for the determination of lincomycin and tylosin residues in honey as part of field studies examining the efficacy and target animal safety of these antibiotics to control American foulbrood disease in honey bees. Residues of the antibiotics were determined using liquid chromatography/electrospray ionization tandem mass spectrometry (LC/ESI-MS/MS). Honey samples were diluted and injected directly into the LC/MS/MS system without additional cleanup by solid-phase extraction or liquid-liquid partitioning. A six-port valve system was utilized to selectively route eluant from the LC column into the mass spectrometer only during a relatively short portion of the chromatographic run corresponding to the elution of the analytes of interest. Minimal contamination of the MS source chamber was observed despite the analysis of large numbers of samples. Using internal standard quantitation, excellent accuracy and precision were obtained with no apparent matrix-to-matrix variation. Based on the analysis of fortified replicates, the mean percent deviation from the theoretical concentration and the percent relative standard deviation were both less than 10% for tylosin over an analytical range of 10-1000 microg/kg. Slightly higher mean percent deviations and relative standard deviations were observed for the analysis of lincomycin in fortified replicate samples. The method detection limits were determined to be 5 and 2 microg/kg for lincomycin and tylosin, respectively.

in position and the sample introduced into the combustion tube 2 to 3 cm. from the copper oxide either as a solid or liquid, directly or in a capillary. The gas line is connected and the reducing mixture and copper oxide are heated. The sample is then pyrolyzed with the same burner used to heat the copper oxide.