Many food preparations, pharmaceuticals, and cosmetics use water-in-oil (W/O) emulsions stabilized by phospholipids. Moreover, recent technological developments try to produce liposomes or lipid coated capsules from W/O emulsions, but are faced with colloidal instabilities. To explore these instability mechanisms, emulsification by sonication was applied in three cycles, and the sample stability was studied for 3 h after each cycle. Clearly identifiable temporal structures of instability provide evidence about the emulsion morphology: an initial regime of about 10 min is shown to be governed by coalescence after which Ostwald ripening dominates. Transport via molecular diffusion in Ostwald ripening is commonly based on the mutual solubility of the two phases and is therefore prohibited in emulsions composed of immiscible phases. However, in the case of water in oil emulsified by phospholipids, these form water-loaded reverse micelles in oil, which enable Ostwald ripening despite the low solubility of water in oil, as is shown for squalene. As is proved for the phospholipid dipalmitoylphosphatidylcholine (DPPC), concentrations below the critical aggregation concentration (CAC) form monolayers at the interfaces and smaller droplet sizes. In contrast, phospholipid concentrations above the CAC create complex multilayers at the interface with larger droplet sizes. The key factors for stable W/O emulsions in classical or innovative applications are first, the minimization of the phospholipids' capacity to form reversed micelles, and second, the adaption of the initial phospholipid concentration to the water content to enable an optimized coverage of phospholipids at the interfaces for the intended drop size.

No abstract

The adsorption of phosphatidylcholines (PCs), dissolved in squalene or squalane as an organic phase, was studied at the interface with water. Using profile analysis tensiometry, the equilibrium adsorption isotherms, minimum molecular interfacial areas, and solubility limits were derived. For squalene, differences in PC solubility and interfacial adsorption were found, depending on PC saturation. Compared to saturated PCs, unsaturated PCs showed a 3-fold-lower interfacial density but up to a 28-fold-higher critical aggregation concentration (CAC). In addition, the solubility limit of unsaturated PC in squalene and in its saturated form squalane diverged by a factor of 739. These findings provided evidence for steric repulsion or π-π interactions of π bonds in both solvent and solute or both effects acting complementarily. In squalane, low solubilities but high interfacial densities were found for all investigated PCs. Changes in fatty acid chain lengths showed that the influence of the increases in entropy and enthalpy on solubility is much smaller than solvent/solute interactions. Oxidation products of squalene lowered the interfacial tension, but increasing concentrations of PC expelled them from the interface. The CAC of saturated PC was increased by oxidation products of squalene whereas that of unsaturated PCs was not. Our findings indicate that the oxidation of triglycerides in lipoprotein cores can lead to increased solubility of saturated phospholipids covering the lipoproteins, contributing to destabilization, coalescence, and terminally the formation of atherosclerotic plaques. The consideration of solvent/solute interactions in molecular modeling may contribute to the interfacial tension and the corresponding kinetic or thermodynamic stability of lipoproteins. Measured areas per molecule prove that PCs form monolayers of different interfacial densities at the squalene/water interface but multilayers at the squalane/water interface. These findings showed that combinations of solvent or solute saturation affect the outcome for nanoemulsions forming either expanded or condensed monolayers or multilayers.