Grinding tools with superabrasive grains can be manufactured from different bond materials. In several industrial applications, metallic bond systems are used. In general, these show good grain retention and offer a high thermal conductivity, when compared to the other widely used bond types such as vitrified and resin bonds. One drawback of the metallic bond is the lack of pores in the grinding layer. This is caused by the manufacturing processes that are typically used, like brazing or hot pressing. These generally produce very dense layers. The high density and low porosity lead to comparatively little space for the transport of lubricant, coolant, and chips. One approach to eliminate this disadvantage is to introduce cavities into the grinding layer, using the laser powder bed fusion technique (LPBF). In order to evaluate the general suitability of LPBF in combination with the bond material and diamond grains, grinding layer samples with a nickel-titanium bond were produced. The abrasive behavior of these samples was tested in scratch tests on cemented carbide to verify the applicability as grinding tools. While the diamond grains in the powder mixture are not part of the fusion process, they also did not interfere with the manufacturing process, and the scratch tests showed promising abrasive capabilities. The grinding layer itself withstood the process forces, and no grain breakout could be observed. This indicates that the grain retention forces are high enough for the grinding process and that NiTi has a high potential as a bonding material for the manufacturing of grinding tools via LPBF.
The grinding of riblets with multiple profiled grinding wheels is an efficient method to minimize the fluid friction on surfaces. In turbo machinery components, like pump impellers or compressor blades, the riblets must be ground with a curved tool path since the flow is rarely linear on such surfaces. This leads to angular errors in the generated riblet profiles and therefore requires the use of grinding wheels with smaller diameters. The tool wear increases due to lateral strain on the peaks of the grinding wheel. Consequently, the increased wear and the need of smaller tool diameters decrease the efficiency of the process. In this paper a structuring process with dicing blades was investigated in order to increase the economic viability of this process. A dressing operation for such tools is not necessary and thus reduces the non-productive time of the manufacturing process. Furthermore, profile tip wear has no negative effects on the aspect ratio of the generated riblets since the riblet geometry is determined by the thickness of the dicing blades.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.