No abstract

Welding fumes vary in composition depending on the materials and processes used, and while health outcomes in full-time welders have been widely studied, limited research on apprentices exists. Besides, few data are available for metals such as vanadium and antimony. This study aimed to look at individual metals present in welding fumes in the learning environment of apprentice welders. Forty-three welders and 41 controls were chosen from trade programmes at the Northern Alberta Institute of Technology. Ambient and personal air samples were collected at days 0, 1, 7, and 50 of their training and analysed for mass and metal concentrations using Inductively Coupled Plasma Mass Spectrometry. Results showed increases in particle and metal concentrations as apprentices progressed throughout their education and that concentrations at day 50 were similar to levels found in the literature for professional welders. Variable concentrations indicate that some individuals may not properly use the local exhaust ventilation system. Other possible explanation for variations are the position of the sampler on the shoulder, the time spent welding and in each welding position, and the skills of the welders. Strong relationships were observed between particle and metal concentrations, suggesting that these relationships could be used to estimate metal exposure in welders from particle exposure. Welding processes were the most important determinant of exposure in apprentice welders, with Metal Core Arc Welding producing the largest particle concentrations followed by oxyacetylene cutting, and Gas Metal Arc Welding. Health risk assessment showed that welder apprentices are at risk for overexposure to manganese, which suggests that professional welders should be monitored for manganese as they are exposed more than apprentices. Training in proper positioning of local exhaust ventilation system and proper use of respirators are recommended in training facilities.

A Monte Carlo simulation technique is used to accurately measure metabolite concentrations in urine.

Abstract. The objective of the project was to develop a method allowing for detailed characterization of welding particles including particle number concentration, size distribution, surface chemistry and chemical composition of individual particles, as well as metal concentration of various welding fumes in personal exposure samples using regular sampling equipment. A sample strategy was developed to evaluate the variation of the collection methods on mass concentration. Samples were collected with various samplers and filters at two different locations using our collection system. The first location was using a robotic welding system while the second was manual welding. Collected samples were analysed for mass concentration using gravimetry and metal concentration using ICP/OES. More advanced analysis was performed on selected filters using X-Ray Photoelectron Spectroscopy to determine surface composition of the particles, and X-Ray Diffraction to determine chemical composition of the fumes. Results showed that the robotic system had a lot of variation in space when the collection system was located close to the weld. Collection efficiency was found to be quite variable depending upon the type of filter. As well, metal concentrations in blank filters were dependent upon the type of filter with MCE presenting with the highest blank values. Results obtained with the XRD and XPS systems showed that it was possible to analyse a small of powdered welding fume sample but results on filters were not conclusive.