This work presents an original approach to create holograms based on the optical scattering of plasmonic nanoparticles. By analogy to the diffraction produced by the scattering of atoms in X-ray crystallography, we show that plasmonic nanoparticles can produce a wave-front reconstruction when they are sampled on a diffractive plane. By applying this method, all of the scattering characteristics of the nanoparticles are transferred to the reconstructed field. Hence, we demonstrate that a narrow-band reconstruction can be achieved for direct white light illumination on an array of plasmonic nanoparticles. Furthermore, multicolor capabilities are shown with minimal cross-talk by multiplexing different plasmonic nanoparticles at subwavelength distances. The holograms were fabricated from a single subwavelength thin film of silver and demonstrate that the total amount of binary information stored in the plane can exceed the limits of diffraction and that this wavelength modulation can be detected optically in the far field.holography | nanotechnology | optics M etallic nanoparticles have been used for centuries to create vibrant colors in works of art. The Lycurgus cup (fourth century), for example, uses metallic nanoparticles to produce a dichroic effect. The nanoparticles are positioned randomly, and the optical characteristics can be approximated using its effective refractive index. Their spectra response depends on the size, shape, and material of the nanoparticles (1). This phenomenon is analogous to the electronic resonance of an antenna in the visible region of the electromagnetic spectrum. In photonics, behavior of this kind is attributed to the interaction of the electric component of light and free electron oscillations in the materials, commonly referred to as surface plasmon resonance (SPR). Although this phenomenon has always fascinated scientists, only over recent years has it been possible to accurately manipulate these structures on the nanoscale due to improved fabrication techniques. In this work, we show a novel approach to produce narrow-band diffraction and holography based on plasmonic enhanced optical scattering of nanostructures. The diffraction produced by the scattering of atoms has been widely studied in X-ray crystallography. We apply a similar concept with 2D arrays of scattering nanoparticles to produce diffraction for visible light. Furthermore, we designed and fabricated a directbeam hologram that produces a narrow-band image when directly observed in reflection. We also achieved colorful holography by placing two independent plasmonic nanostructures in a subwavelength distance to diffract two colors simultaneously. In contrast with dielectric multiplexing of nansutructures, we show that metallic nanoparticles can be uncoupled because of their plasmonic properties. This feature allows them to carry independent wavelength information without cross-talk.In the traditional concept of holography, the fringes that produce diffraction are larger than half the wavelength. For instance, accor...

We prove theoretically and experimentally the concept of polarization holography by producing visible diffraction through radiation emitted by plasmonic nanoantennas. We show a methodology to selectively activate the nanoantenna emission by controlling the orientation of the electric field of a beam. Additionally, we demonstrate that it is possible to superpose two independent transverse nanoantennas in the same plane without producing interference in their radiated field. Hence, we introduce an alternative view to the traditional concept of holography where fringes (or diffractive units) are band-limited to half the wavelength.

Single photon detectors are indispensable tools in optics, from fundamental measurements to quantum information processing. The ability of superconducting nanowire single photon detectors (SNSPDs) to detect single photons with unprecedented efficiency, short dead time, and high time resolution over a large frequency range enabled major advances in quantum optics. However, combining near-unity system detection efficiency (SDE) with high timing performance remains an outstanding challenge. In this work, we fabricated novel SNSPDs on membranes with 99.5−2.07+0.5% SDE at 1350 nm with 32 ps timing jitter (using a room-temperature amplifier), and other detectors in the same batch showed 94%–98% SDE at 1260–1625 nm with 15–26 ps timing jitter (using cryogenic amplifiers). The SiO2/Au membrane enables broadband absorption in small SNSPDs, offering high detection efficiency in combination with high timing performance. With low-noise cryogenic amplifiers operated in the same cryostat, our efficient detectors reach a timing jitter in the range of 15–26 ps. We discuss the prime challenges in optical design, device fabrication, and accurate and reliable detection efficiency measurements to achieve high performance single photon detection. As a result, the fast developing fields of quantum information science, quantum metrology, infrared imaging, and quantum networks will greatly benefit from this far-reaching quantum detection technology.

Digital holography requires arrays of small reconfigurable elements to achieve complex reconstruction of the hologram with common systems based on pixels utilizing liquid crystal on silicon (LCoS) technology. The backplane of a typical pixel element is potentially underutilized and thus relatively large physical areas exist in which information can be stored and exploited to give additional functionality to pixel elements. Polarisation and wavelength dependent optical properties can be achieved in small areas using the plasmonic effects of optical antennae. The integration of LCs with optical antennae‐based plasmonic holograms allows active modulation of the far field pattern. The work here demonstrates the concept that conventional LCoS pixel elements can be greatly enhanced with the integration of plasmonic holograms, composed of optical antennae patterned on the surface, giving rise to new levels of modulation capability for holographic pixel elements. Using LCs, polarisation dependent effects in plasmonic holograms can be switched. ‘Engineered pixels', with sub‐wavelength multiplexing over both polarisation and wavelength, can increase the channel capacity of a typical LC display device. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)

Electronic defect states at material interfaces provide highly deleterious sources of noise in solid-state nanostructures, and even a single trapped charge can qualitatively alter the properties of short one-dimensional nanowire field-effect transistors (FET) and quantum bit (qubit) devices. Understanding the dynamics of trapped charge is thus essential for future nanotechnologies, but their direct detection and manipulation is rather challenging. Here, a transistor-based set-up is used to create and probe individual electronic defect states that can be coherently driven with microwave (MW) pulses. Strikingly, we resolve a large number of very high quality (Q ∼ 1 × 10) resonances in the transistor current as a function of MW frequency and demonstrate both long decoherence times (∼1 μs-40 μs) and coherent control of the defect-induced dynamics. Efficiently characterizing over 800 individually addressable resonances across two separate defect-hosting materials, we propose that their properties are consistent with weakly driven two-level systems.