Electronic absorption spectra of the low-lying pipi(*) and pisigma(*) states of several aminobenzonitriles and 4-dimethylaminobenzethyne have been studied by time-resolved transient absorption and time-dependent density functional theory calculation. In acetonitrile, the lifetime of the pisigma(*)-state absorption is very short (picoseconds or subpicosecond) for molecules that exhibit intramolecular charge transfer (ICT), and very long (nanoseconds) for those that do not. Where direct comparison of the temporal characteristics of the pisigma(*)-state and the ICT-state transients could be made, the formation rate of the ICT state is identical to the decay rate of the pisigma(*) state within the experimental uncertainty. These results are consistent with the pisigma(*)-mediated ICT mechanism, L(a) (pipi(*))-->pisigma(*)-->ICT, in which the decay rate of the pisigma(*) state is determined by the rate of the solvent-controlled pisigma(*)-->ICT charge-shift reaction. The pipi(*)-->pisigma(*) state crossing does not occur in 3-dimethylaminobenzonitrile or 2-dimethylaminobenzonitrile, as predicted by the calculation, and 4-aminobenzonitrile and 4-dimethylaminobenzethyne does not exhibit the ICT reaction, consistent with the higher energy of the ICT state relative to the pisigma(*) state.

No abstract

No abstract

Beacons using bluetooth low-energy (BLE) technology have emerged as a new paradigm of indoor positioning service (IPS) because of their advantages such as low power consumption, miniaturization, wide signal range, and low cost. However, the beacon performance is poor in terms of the indoor positioning accuracy because of noise, motion, and fading, all of which are characteristics of a bluetooth signal and depend on the installation location. Therefore, it is necessary to improve the accuracy of beacon-based indoor positioning technology by fusing it with existing indoor positioning technology, which uses Wi-Fi, ZigBee, and so forth. This study proposes a beacon-based indoor positioning method using an extended Kalman filter that recursively processes input data including noise. After defining the movement of a smartphone on a flat two-dimensional surface, it was assumed that the beacon signal is nonlinear. Then, the standard deviation and properties of the beacon signal were analyzed. According to the analysis results, an extended Kalman filter was designed and the accuracy of the smartphone’s indoor position was analyzed through simulations and tests. The proposed technique achieved good indoor positioning accuracy, with errors of 0.26 m and 0.28 m from the average x- and y-coordinates, respectively, based solely on the beacon signal.

A concerted experimental and computational study of 4-(dimethylamino)benzethyne, DMABE, has been carried out to probe the low-lying pisigma* state and the role it plays in the photophysics of the molecule. The subpicosecond transient absorption spectra reveal the presence of a strong excited-state absorption at about 700 nm and a weaker absorption at about 520 nm. The observed absorption maxima are in excellent agreement with the TDDFT calculations that place a strongly allowed pisigma* <--pisigma* transition at 750 nm, and a weaker pipi* <--pipi* (LE) transition at 528 nm. This agreement combined with the differing decay times, and differing solvent shifts of the two transients, allow assignments of the 700 nm absorption to the pisigma* state and the 520 nm absorption to the LE (pipi*) state. The bifurcation of the initially excited L(a) (pipi*) state into the pisigma* state and the LE state, as probed by transient absorption, is strongly influenced by solvent polarity, with polar environments favoring the L(a)-->pisigma* decay channel over the competing L(a)--> LE decay channel. The nanosecond radiationless decay of the LE state to the dark pisigma* state is also strongly enhanced in polar environments, thus accounting for the dramatic quenching of fluorescence in solvents of high polarity.