The aim of this study was to test the ability of an infrared (IR) camera to assess temperature changes and distributions in teeth below restorations when quartz-tungstenhalogen (QTH) and light-emitting diode (LED) curing lights were used to photopolymerize the restorative material. Our hypothesis was that the higher power density and broader spectral distribution of the QTH source would cause greater increases in tooth temperature than the LED source, and that these differences would be best demonstrated with the IR camera. Cavities were prepared on human third molars and restored with a resin composite restorative material. The material was light-cured using three light-curing sources using several exposure times. The external (outside the tooth) and internal (inside the pulp chamber) temperature changes during polymerization of the composite material were recorded over 360 s with thermocouples and an IR camera. Using thermocouples the maximum increase in external temperature (؉17.7°C) was reported for the Swiss Master light after 20 s of curing time while the minimum temperature rise (؉7.8°C) was reported for the Freelight 2. Whereas a 2.6°C increase in internal temperature was observed after curing 20 s with the Freelight 2, 7.1°C was reported after 60 s of light exposure to Astralis 10. Infrared images showed similar trends in external-internal rises in temperature as the thermocouples, although temperatures measured by the IR were generally higher. These results indicate that the higher power density QTH sources caused greater increases in tooth temperatures than the LED source and that thermocouples may underestimate the heat applied to the tooth.

d e n t a l m a t e r i a l s 2 2 ( 2 0 0 6 ) 896-902 a v a i l a b l e a t w w w . s c i e n c e d i r e c t . c o m j o u r n a l h o m e p a g e : w w w . i n t l . e l s e v i e r h e a l t h . c o m / j o u r n a l s / d e m a Objectives. In the current study, we used electronic speckle pattern interferometry (ESPI) to measure tooth deformation in response to polymerization of five resin composites with a range of polymerization shrinkage. Our hypothesis was that composites with higher polymerization shrinkage should cause more cuspal strain as measured by ESPI.Methods. Standardized MOD cavities were prepared and placed into the ESPI apparatus before the cavities were filled with composites (n = 10). The ESPI apparatus was constructed to measure the out-of-plane displacement of the lingual cusps of the teeth during the polymerization of the restorative material. A thermocouple was attached to the specimen to monitor thermal changes throughout the polymerization process. Results. Experiments with empty preparations demonstrated that the ESPI technique wastemporally responsive and sensitive to dimensional changes. However, the correlation between polymerization shrinkage of composite resins and ESPI-measured tooth deformation was not straightforward. In particular, a flowable material did not deform the tooth significantly more that a conventional hybrid. Further, an experimental silorane material (with the lowest axial shrinkage) induced the least tooth deformation.Significance. We concluded that ESPI is a viable method for assessing cuspal strain induced by shrinkage of bonded composite restorations, but that polymerization shrinkage data may overestimate shrinkage-induced tooth deformation. The rate of polymerization shrinkage appeared to mediate the development of cuspal strain.