Most cochlear implants (CIs) activate their electrodes non-simultaneously in order to eliminate electrical field interactions. However, the membrane of auditory nerve fibers needs time to return to its resting state, causing the probability of firing to a pulse to be affected by previous pulses. Here, we provide new evidence on the effect of pulse polarity and current level on these interactions. In experiment 1, detection thresholds and most comfortable levels (MCLs) were measured in CI users for 100-Hz pulse trains consisting of two consecutive biphasic pulses of the same or of opposite polarity. All combinations of polarities were studied: anodic-cathodic-anodic-cathodic (ACAC), CACA, ACCA, and CAAC. Thresholds were lower when the adjacent phases of the two pulses had the same polarity (ACCA and CAAC) than when they were different (ACAC and CACA). Some subjects showed a lower threshold for ACCA than for CAAC while others showed the opposite trend demonstrating that polarity sensitivity at threshold is genuine and subject- or electrode-dependent. In contrast, anodic (CAAC) pulses always showed a lower MCL than cathodic (ACCA) pulses, confirming previous reports. In experiments 2 and 3, the subjects compared the loudness of several pulse trains differing in current level separately for ACCA and CAAC. For 40 % of the electrodes tested, loudness grew non-monotonically as a function of current level for ACCA but never for CAAC. This finding may relate to a conduction block of the action potentials along the fibers induced by a strong hyperpolarization of their central processes. Further analysis showed that the electrodes showing a lower threshold for ACCA than for CAAC were more likely to yield a non-monotonic loudness growth. It is proposed that polarity sensitivity at threshold reflects the local neural health and that anodic asymmetric pulses should preferably be used to convey sound information while avoiding abnormal loudness percepts.

Three experiments on loudness of sounds with linearly increasing levels were performed: global loudness was measured using direct ratings, loudness change was measured using direct and indirect estimations. Results revealed differences between direct and indirect estimations of loudness change, indicating that the underlying perceptual phenomena are not the same. The effect of ramp size is small for the former and important for the latter. A similar trend was revealed between global loudness and direct estimations of loudness change according to the end level, suggesting they may have been confounded. Measures provided by direct estimations of loudness change are more participant-dependent.

Animals use tools for communication relatively rarely compared to tool use for extractive foraging. We investigated the tool-use behaviour accumulative stone throwing (AST) in wild chimpanzees, who regularly throw rocks at trees, producing impact sounds and resulting in the aggregations of rocks. The function of AST remains unknown but appears to be communication-related. We conducted field experiments to test whether impact sounds produced by throwing rocks at trees varied according to the tree's properties. Specifically, we compared impact sounds of AST and non-AST tree species. We measured three acoustic descriptors related to intrinsic timbre quality, and found that AST tree species produced impact sounds that were less damped, with spectral energy concentrated at lower frequencies compared to non-AST tree species. Buttress roots in particular produced timbres with low-frequency energy (low spectral centroid) and slower signal onset (longer attack time). In summary, chimpanzees use tree species capable of producing more resonant sounds for AST compared to other tree species available.