Wheat yields globally will depend increasingly on good management to conserve rainfall and new varieties that use water efficiently for grain production. Here we propose an approach for developing new varieties to make better use of deep stored water. We focus on water-limited wheat production in the summer-dominant rainfall regions of India and Australia, but the approach is generally applicable to other environments and root-based constraints. Use of stored deep water is valuable because it is more predictable than variable in-season rainfall and can be measured prior to sowing. Further, this moisture is converted into grain with twice the efficiently of in-season rainfall since it is taken up later in crop growth during the grain-filling period when the roots reach deeper layers. We propose that wheat varieties with a deeper root system, a redistribution of branch root density from the surface to depth, and with greater radial hydraulic conductivity at depth would have higher yields in rainfed systems where crops rely on deep water for grain fill. Developing selection systems for mature root system traits is challenging as there are limited high-throughput phenotyping methods for roots in the field, and there is a risk that traits selected in the lab on young plants will not translate into mature root system traits in the field. We give an example of a breeding programme that combines laboratory and field phenotyping with proof of concept evaluation of the trait at the beginning of the selection programme. This would greatly enhance confidence in a high-throughput laboratory or field screen, and avoid investment in screens without yield value. This approach requires careful selection of field sites and years that allow expression of deep roots and increased yield. It also requires careful selection and crossing of germplasm to allow comparison of root expression among genotypes that are similar for other traits, especially flowering time and disease and toxicity resistances. Such a programme with field and laboratory evaluation at the outset will speed up delivery of varieties with improved root systems for higher yield.

Abstract. Better understanding of root system structure and function is critical to crop improvement in waterlimited environments. The aims of this study were to examine root system characteristics of two wheat genotypes contrasting in tolerance to water limitation and to assess the functional implications on adaptation to water-limited environments of any differences found. The drought tolerant barley variety, Mackay, was also included to allow inter-species comparison. Single plants were grown in large, soil-filled root-observation chambers. Root growth was monitored by digital imaging and water extraction was measured. Root architecture differed markedly among the genotypes. The drought-tolerant wheat (cv. SeriM82) had a compact root system, while roots of barley cv. Mackay occupied the largest soil volume. Relative to the standard wheat variety (Hartog), SeriM82 had a more uniform rooting pattern and greater root length at depth. Despite the more compact root architecture of SeriM82, total water extracted did not differ between wheat genotypes. To quantify the value of these adaptive traits, a simulation analysis was conducted with the cropping system model APSIM, for a wide range of environments in southern Queensland, Australia. The analysis indicated a mean relative yield benefit of 14.5% in water-deficit seasons. Each additional millimetre of water extracted during grain filling generated an extra 55 kg ha −1 of grain yield. The functional implications of root traits on temporal patterns and total amount of water capture, and their importance in crop adaptation to specific water-limited environments, are discussed.

A crop's ability to explore the soil profile and extract available water at different depths is largely determined by root system architecture. For instance in wheat (Triticum aestivum L.), it has been suggested that a narrow and deep root system can provide better access to deep soil moisture. Such root systems are particularly beneficial for rain-fed regions where crops rely heavily on stored soil moisture at depth, as encountered in the eastern Australian wheat belt. Thus, by targeting desirable root architectural traits, wheat breeders could increase genetic gain for yield in response to the growing demand for food. Yet, selection for these below-ground traits is challenging because roots are difficult to measure and are under complex genetic control. The aim of this project was to develop new phenotypic and molecular selection tools to facilitate selection for root architectural traits in Australian wheat breeding programs targeting terminal moisture stress adaptation. This project focuses on narrow seminal root angle and high number of seminal roots in wheat seedlings; two proxy traits for desirable mature root system architecture. Firstly, to overcome the lack of efficient root screening methods, a high-throughput and cost-effective method for phenotyping seminal root angle and number in wheat was developed, using clear pots in a controlled environment growth facility. Compared to pre-existing phenotyping methods, the newly developed method successfully provided higher heritability, greater repeatability, and better efficiency in terms of time, space, and labour. Further, the clear-pot method revealed a high degree of phenotypic variation for both seminal root traits. Subsequently, to test the ability to introgressed allelic variation for seminal root angle into elite Australian wheat cultivars via phenotypic selection, backcross tail populations for both narrow and wide root angle were developed, using the clear-pot method. Rapid shifts in both population distribution and allele frequency were observed after just two rounds of selection. Further, comparison of the tail populations revealed some genomic regions under selection, for which marker-assisted selection appeared successful. Hence, genetic diversity can be exploited via phenotypic and molecular selection to target desired root system architecture in wheat breeding programs.

No abstract

BackgroundWater availability is a major limiting factor for wheat (Triticum aestivum L.) production in rain-fed agricultural systems worldwide. Root system architecture has important functional implications for the timing and extent of soil water extraction, yet selection for root architectural traits in breeding programs has been limited by a lack of suitable phenotyping methods. The aim of this research was to develop low-cost high-throughput phenotyping methods to facilitate selection for desirable root architectural traits. Here, we report two methods, one using clear pots and the other using growth pouches, to assess the angle and the number of seminal roots in wheat seedlings– two proxy traits associated with the root architecture of mature wheat plants.ResultsBoth methods revealed genetic variation for seminal root angle and number in the panel of 24 wheat cultivars. The clear pot method provided higher heritability and higher genetic correlations across experiments compared to the growth pouch method. In addition, the clear pot method was more efficient – requiring less time, space, and labour compared to the growth pouch method. Therefore the clear pot method was considered the most suitable for large-scale and high-throughput screening of seedling root characteristics in crop improvement programs.ConclusionsThe clear-pot method could be easily integrated in breeding programs targeting drought tolerance to rapidly enrich breeding populations with desirable alleles. For instance, selection for narrow root angle and high number of seminal roots could lead to deeper root systems with higher branching at depth. Such root characteristics are highly desirable in wheat to cope with anticipated future climate conditions, particularly where crops rely heavily on stored soil moisture at depth, including some Australian, Indian, South American, and African cropping regions.

Root architecture traits in wheat are important in deep soil moisture acquisition and may be used to improve adaptation to water-limited environments. The genetic architecture of two root traits, seminal root angle and seminal root number, were investigated using a doubled haploid population derived from SeriM82 and Hartog. Multiple novel quantitative trait loci (QTL) were identified, each one having a modest effect. For seminal root angle, four QTL (-log10(P) >3) were identified on 2A, 3D, 6A and 6B, and two suggestive QTL (-log10(P) >2) on 5D and 6B. For root number, two QTL were identified on 4A and 6A with four suggestive QTL on 1B, 3A, 3B and 4A. QTL for root angle and root number did not co-locate. Transgressive segregation was found for both traits. Known major height and phenology loci appear to have little effect on root angle and number. Presence or absence of the T1BL.1RS translocation did not significantly influence root angle. Broad sense heritability (h (2)) was estimated as 50 % for root angle and 31 % for root number. Root angle QTL were found to be segregating between wheat cultivars adapted to the target production region indicating potential to select for root angle in breeding programs.

WLR1, a biotype of Lolium rigidum Gaud. that had been treated with the sulfonylurea herbicide chlorsulfuron in 7 consecutive years, was found to be resistant to both the wheat-selective and the nonselective sulfonylurea and imidazolinone herbicides. Biotype SLR31, which became cross-resistant to chlorsulfuron following treatment with the aryloxyphenoxypropionate herbicide diclofop-methyl, was resistant to the wheat-selective, but not the nonselective, sulfonylurea and imidazolinone herbicides. The concentrations of herbicide required to reduce in vitro acetolactate synthase (ALs) activity 50% with respect to control assays minus herbicide for biotype WLR1 was greater than those for susceptible biotype VLR1 by a factor of >30, >30, 7, 4, and 2 for the herbicides chlorsulfuron, sulfometuron-methyl, imazapyr, imazathapyr, and imazamethabenz, respectively. ALS activity from biotype SLR31 responded in a similar manner to that of the susceptible biotype VLR1. The resistant biotypes metabolized chlorsulfuron more rapidly than the susceptible biotype. Metabolism of 50% of [phenyl-U-14C]chlorsulfuron in the culms of two-leaf seedlings required 3.7 h in biotype SLR31, 5.1 h in biotype WLR1, and 7.1 h in biotype VLR1. In all biotypes the metabolism of chlorsulfuron in the culms was more rapid than that in the leaf lamina. Resistance to ALS inhibitors in L. rigidum may involve at least two mechanisms, increased metabolism of the herbicide and/or a herbicide-insensitive ALS.

No abstract