No abstract

No abstract

This paper will discuss the design and construction of BESIII [1], which is designed to study physics in the τ-charm energy region utilizing the new high luminosity BEPCII double ring e + ecollider [2]. The expected performance will be given based on Monte Carlo simulations and results of cosmic ray and beam tests. In BESIII, tracking and momentum measurements for charged particles are made by a cylindrical multilayer drift chamber in a 1 T superconducting solenoid. Charged particles are identified with a time-of-flight system based on plastic scintillators in conjunction with dE/dx (energy loss per unit pathlength) measurements in the drift chamber. Energies of electromagnetic showers are measured by a CsI(Tl) crystal calorimeter located inside the solenoid magnet. Muons are identified by arrays of resistive plate chambers in the steel magnetic flux return. The level 1 trigger system, Data Acquisition system and the event filter system based on networked computers will also be described.

We study the process e + e − → π + π − J/ψ at a center-of-mass energy of 4.260 GeV using a 525 pb −1 data sample collected with the BESIII detector operating at the Beijing Electron Positron Collider. The Born cross section is measured to be (62.9 ± 1.9 ± 3.7) pb, consistent with the production of the Y (4260). We observe a structure at around 3.9 GeV/c 2 in the π ± J/ψ mass spectrum, which we refer to as the Zc(3900). If interpreted as a new particle, it is unusual in that it carries an electric charge and couples to charmonium. A fit to the π ± J/ψ invariant mass spectrum, neglecting interference, results in a mass of (3899.0 ± 3.6 ± 4.9) MeV/c 2 and a width 3 of (46 ± 10 ± 20) MeV. Its production ratio is measured to be R = σ(e + e − →π ± Zc(3900) ∓ →π + π − J/ψ)) σ(e + e − →π + π − J/ψ) = (21.5 ± 3.3 ± 7.5)%. In all measurements the first errors are statistical and the second are systematic. PACS numbers: 14.40.Rt, 14.40.Pq, 13.66.Bc Since its discovery in the initial-state-radiation (ISR) process e + e − → γ ISR π + π − J/ψ [1], and despite its subsequent observations [2][3][4][5], the nature of the Y (4260) state has remained a mystery. Unlike other charmonium states with the same quantum numbers and in the same mass region, such as the ψ (4040) A similar situation has recently become apparent in the bottomonium system above the BB threshold, where there are indications of anomalously large couplings between the Υ(5S) state (or perhaps an unconventional bottomonium state with similar mass, the Y b (10890)) and the π + π − Υ(1S, 2S, 3S) and π + π − h b (1P, 2P ) final states [14,15]. More surprisingly, substructure in these π + π − Υ(1S, 2S, 3S) and π + π − h b (1P, 2P ) decays indicates the possible existence of charged bottomoniumlike states [16], which must have at least four constituent quarks to have a non-zero electric charge, rather than the two in a conventional meson. By analogy, this suggests there may exist interesting substructure in the Y (4260) → π + π − J/ψ process in the charmonium region.In this Letter, we present a study of the process e + e − → π + π − J/ψ at a center-of-mass (CM) energy of √ s = (4.260± 0.001) GeV, which corresponds to the peak of the Y (4260) cross section. We observe a charged structure in the π ± J/ψ invariant mass spectrum, which we refer to as the Z c (3900). The analysis is performed with a 525 pb −1 data sample collected with the BESIII detector, which is described in detail in Ref. [17]. In the studies presented here, we rely only on charged particle tracking in the main drift chamber (MDC) and energy deposition in the electromagnetic calorimeter (EMC).The GEANT4-based Monte Carlo (MC) simulation software, which includes the geometric description of the BE-SIII detector and the detector response, is used to optimize the event selection criteria, determine the detection efficiency, and estimate backgrounds. For the signal process, we use a sample of e + e − → π + π − J/ψ MC events generated assuming the π + π − J/ψ is produced via Y (4260) decays, and using the...

No abstract

No abstract

The Daya Bay Reactor Neutrino Experiment is designed to determine precisely the neutrino mixing angle θ 13 with a sensitivity better than 0.01 in the parameter sin 2 2θ 13 at the 90% confidence level. To achieve this goal, the collaboration will build eight functionally identical antineutrino detectors. The first two detectors have been constructed, installed and commissioned in Experimental Hall 1, with steady data-taking beginning September 23, 2011. A comparison of the data collected over the subsequent three months indicates that the detectors are functionally identical, and that detector-related systematic uncertainties exceed requirements.

The numbers of ψ(3686) events accumulated by the BESIII detector for the data taken during 2009 and 2012 are determined to be (107.0±0.8)×10 6 and (341.1±2.1)×10 6 , respectively, by counting inclusive hadronic events, where the uncertainties are systematic and the statistical uncertainties are negligible. The number of events for the sample taken in 2009 is consistent with that of the previous measurement. The total number of ψ(3686) events for the two data taking periods is (448.1±2.9)×10 6 .