C-axis vertically aligned ZnO nanorod arrays were synthesized on a ZnO thin film through a simple hydrothermal route. The nanorods have a diameter of 30–100 nm and a length of about several hundred nanometres. The gas sensor fabricated from ZnO nanorod arrays showed a high sensitivity to H2 from room temperature to a maximum sensitivity at 250 °C and a detection limit of 20 ppm. In addition, the ZnO gas sensor also exhibited excellent responses to NH3 and CO exposure. Our results demonstrate that the hydrothermally grown vertically aligned ZnO nanorod arrays are very promising for the fabrication of cost effective and high performance gas sensors.

Hydrothermally synthesized ZnO nanotube arrays were used to fabricate the gas sensor for detection of the toxic gas NO2. The ZnO nanotube gas sensor exhibited sensitive response to NO2 down to 500 ppb at low temperature 30 degrees C. Abnormal temperature-dependent and concentration-dependent N-P transition behaviors were observed. The excellent sensing ability of the sensor and their anomalous conductivity behaviors may be attributed to the unique surface conductivity related to the hollow nanostructure feature. These sensing behaviors may help to comprehensively understand the sensing mechanism of 1D ZnO nanostructures and improve the selectivity of the ZnO gas sensor.

We report an electrochromic (EC) display using a viologen-modified ZnO nanowire array as the EC electrode. The ZnO nanowire array was grown directly on an indium tin oxide (ITO) glass by a low temperature aqueous thermal decomposition method and then modified with viologen molecules. The ZnO nanowire electrochromic device shows fast switching time (170 and 142 ms for coloration and bleaching respectively for a 1 cm (2) cell), high coloration efficiency (196 C (-1) cm (2)) and good stability. The improved performance of the ZnO nanowires EC device can be attributed to the large surface area and high crystalline and good electron transport properties of the ZnO nanowire array.

A modified hydrothermal method was developed to synthesize ZnO-CuO composite nanostructures. A free-standing film made of ZnO-CuO nanostructures was assembled on the surface of the hydrothermal solution with a smooth surface on one side and a spherical surface on the other side. The structure, growth mechanism and the optical properties of the composite nanostructures were studied. Structural characterizations indicate that the composite nanostructure mainly consisted of two single-crystal phases of CuO and ZnO. The sensitivity for CO gas detection was significantly improved for the composite CuO-ZnO nanostructure film. This method offers a possible route for the fabrication of free-standing nanostructure films of different functional composite oxides.

Injector-like zinc oxide (ZnO) nanostructures have been synthesized on Si substrate by the vapour phase transport method. Samples with different areal densities were obtained by controlling the temperature. The field emission properties of the injector-like ZnO nanostructures showed a clear dependence on the areal density of the nanostructures, which is due to the screening effect. The samples with a needle length of 850 nm and an areal density of 1 × 10(8) cm(-2) showed the lowest field emission turn-on field of 1.85 V µm(-1) at a current density of 10 µA cm(-2), and the current density reaches 1 mA cm(-2) at an applied field of 4.7 V µm(-1).

No abstract