The scope of this paper is to illustrate the need for an improved quality assurance in fluorometry. For this purpose, instrumental sources of error and their influences on the reliability and comparability of fluorescence data are highlighted for frequently used photoluminescence techniques ranging from conventional macro-and microfluorometry over fluorescence microscopy and flow cytometry to microarray technology as well as in vivo fluorescence imaging. Particularly, the need for and requirements on fluorescence standards for the characterization and performance validation of fluorescence instruments, to enhance the comparability of fluorescence data, and to enable quantitative fluorescence analysis are discussed. Special emphasis is dedicated to spectral fluorescence standards and fluorescence intensity standards.

We present three-dimensional microfluidic structures with integrated optical fibers, mirrors and electrodes for flow cytometric analysis of blood cells. Ultraprecision milling technique was used to fabricate different flow cells featuring single-stage and two-stage cascaded hydrodynamic focusing of particles by a sheath flow. Two dimensional focussing of the sample fluid was proven by fluorescence imaging in horizontal and vertical directions and found to agree satisfactorily with finite element calculations. Focussing of the sample stream down to 5 microm at a particle velocity of 3 m s(-1) is accessible while maintaining stable operation for sample flow rates of up to 20 microL min(-1). In addition to fluorescence imaging, the micro-flow cells were characterised by measurements of pulse shapes and pulse height distributions of monodisperse microspheres. We demonstrated practical use of the microstructures for cell differentiation employing light scatter to distinguish platelets and red blood cells. Furthermore, T-helper lymphocytes labelled by monoclonal antibodies were identified by measuring side scatter and fluorescence.

No abstract

This study demonstrates the suitability of microfluidic structures for high throughput blood cell analysis. The microfluidic chips exploit fully integrated hydrodynamic focusing based on two different concepts: Two-stage cascade focusing and spin focusing (vortex) principle. The sample—A suspension of micro particles or blood cells—is injected into a sheath fluid streaming at a substantially higher flow rate, which assures positioning of the particles in the center of the flow channel. Particle velocities of a few m/s are achieved as required for high throughput blood cell analysis. The stability of hydrodynamic particle positioning was evaluated by measuring the pulse heights distributions of fluorescence signals from calibration beads. Quantitative assessment based on coefficient of variation for the fluorescence intensity distributions resulted in a value of about 3% determined for the micro-device exploiting cascade hydrodynamic focusing. For the spin focusing approach similar values were achieved for sample flow rates being 1.5 times lower. Our results indicate that the performances of both variants of hydrodynamic focusing suit for blood cell differentiation and counting. The potential of the micro flow cytometer is demonstrated by detecting immunologically labeled CD3 positive and CD4 positive T-lymphocytes in blood.

The real part of the refractive index (RI) of aqueous solutions of human hemoglobin is computed from their absorption spectra in the wavelength range 250 nm-1100 nm using the Kramers-Kronig (KK) relations and the corresponding uncertainty analysis is provided. The strong ultraviolet (UV) and infrared absorbance of the water outside this spectral range were taken into account in a previous study employing KK relations. We improve these results by including the concentration dependence of the water absorbance as well as by modeling the deep UV absorbance of hemoglobin's peptide backbone. The two free parameters of the model for the deep UV absorbance are fixed by a global fit.