The partitioning coefficient of a surfactant between oil and water is related to the free energy of transfer from one phase to the other. The influence of temperature on the partition coefficient of octylphenol ethoxylate oligomers between oil and water is reported. The variation of the partition coefficient with formulation variables can be used as a yardstick for the concept of generalized formulation expression.

Despite claims, based largely on molecular dynamics simulations, that the surface of water at the air/water interface is acidic, with a positive charge, there is compelling experimental evidence that it is in fact basic, with a negative charge due to the specific adsorption of hydroxide ions. The oil/water interface behaves similarly. The pH dependence of the zeta potentials of oil drops has been measured by two very different techniques: on a single drop in a rotating electrophoresis cell and on about 10(14) submicrometer drops in a 2 vol % emulsion by an electroacoustic method to give similar results with a sigmoidal pH dependence characterized by an isoelectric point at pH 2-3 and a half adsorption point about pH 5.5, or at 10(-8.5) M hydroxide ion. This indicates that hydroxide ion is absorbed much more strongly than other anions. The pH dependence of a single N(2) bubble has also been measured and has the same pH dependence, independently of whether HCl or HI is used to adjust the pH. These similarities between the pH dependences of the zeta potentials of air bubbles and oil drops, as well as those reported from streaming potentials on solid inert surfaces such as Teflon, indicate that water behaves similarly, with only subtle differences, at each of these low dielectric hydrophobic surfaces, with an isoelectric point of pH 2-4. In acidic solutions at pH's below the isoelectric point, the surface is indeed positive, consistent with spectroscopic observations of the adsorption of hydrogen ions.

The stability of water-in-oil emulsions formed during oil slicks or petroleum production operations is ensured by natural surfactant molecules (principally asphaltenes) that are present in the crude oil. These persistent emulsions may be broken by adding a suitable demulsifier at the proper concentration to attain a so-called optimum formulation at which the stability of the emulsion is minimum. In this report, the concentration of asphaltenes is varied by diluting the crude oil with a solvent such as cyclohexane, toluene, or mixtures of them. The experimental evidence shows that there exists some critical asphaltene concentration at which the interfacial zone seems to be saturated. Beyond this threshold, which is typically around 1000 ppm of asphaltenes, the demulsifier concentration necessary to attain the emulsionʼs quickest breaking is constant. Below it, e.g. when the crude is highly diluted with a solvent, the optimum demulsifier concentration is found to be proportional to the asphaltene concentration. The map of emulsion stability versus asphaltene and demulsifier concentrations exhibits a typical pattern for different demulsifiers and diluents, which contributes to improving the interpretation of the demulsifying action.