This report was prepared as an account of work sponsored by an agency of the United States Government. Neither the United States Government nor any agency thereof, nor any of their employees, makes any warranty, express or implied, or assumes any legal liability or responsibility for the accuracy, completeness, or usefulness of any information, apparatus, product, or process disclosed, or represents that its use would not infringe privately owned rights. Refer-nnC/CT/7R99lt 1 ence herein to any specific commercial product, process, or service by trade name, trademark, UUC/CI \i.W^J manufacturer, or otherwise does not necessarily constitute or imply its endorsement, recom-GA-A16713 mendation, or favoring by the United States Government or any agency thereof. The views and opinions of authors expressed herein do not necessarily state or reflect those of the Uw'tl4u United States Government or any agency thereof.
Rates of flow of pure gases, both those with no adsorption and those with appreciable adsorption, were studied as a function of pressure level, pressure drop, and temperature for flow through 1/2-in.-diameter cylindrical plugs of activated carbon and of unsintered Vycor glass. Adsorption isotherms for the pure gases on Vycor glass were measured over the range of variables covered in the flow studies. A few measurements were made for bulk liquid flowing through a Vycor plug.Permeabilities, which are proportional to the rate of flow per unit of pressure drop, were satisfactorily correlated for hydrogen, helium, argon, and nitrogen by employing existing gas-phase flow theory. Permeabilities considerably larger than the values predicted from the nonadsorbed gas correlation, sometimes more than seventeen times as large, were observed for ethylene, propylene, and isobutane flowing through a Vycor plug. For the hydrocarbon-Vycor systems, permeabilities for vapor flow are as much as sixty times larger than for bulk liquid flow.The unusual flow phenomena for the hydrocarbon-Vycor systems are attributed to a rapid transport in the adsorbed layer. The total transport is treated as being the sum of gas-phase and adsorbed-layer flow. An equation describing adsorbed-layer movement is derived by utilizing a force balance together with thermodynamic principles. The resulting equation has just one empirical constant, and its use requires adsorption-isotherm data. It correlates very well the surface flow rates for the major range of the variables covered in this investigation. Rate measurements were made for adsorbed-lager concentrations ranging from about one tenth of a monolayer up through the capillary condensation region. Deviations in the one constant form of the equation are observed below one tenth of a monolayer. The available literature data on flow in adsorbed layers are reasonably well correlated by the same equation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.