This paper reports the results of a series of tests designed to determine the melting and subsequent deposition behavior of volcanic ash cloud materials in modern gas turbine engine combustors and high pressure turbine vanes. The specific materials tested were Mt. St. Helens ash and a soil blend containing volcanic ash (black scoria) from Twin Mountain, New Mexico. Hot section test systems were built using actual engine combustors, fuel nozzles, ignitors, and high pressure turbine vanes from an Allison T56 engine can-type combustor and a more modern Pratt and Whitney F-100 engine annular-type combustor. A rather large turbine inlet temperature range can be achieved using these two combustors. The deposition behavior of volcanic materials as well as some of the parameters that govern whether or not these volcanic ash materials melt and subsequently deposit are discussed.
Time-averaged Stanton number and surface-pressure distributions are reported for the first-stage vane row and the first-stage blade row of the Rocketdyne Space Shuttle Main Engine two-stage fuel-side turbine. These measurements were made at 10%, 50%, and 90% span on both the pressure and suction surfaces of the component. Stanton-number distributions are also reported for the second-stage vane at 50% span. A shock tube is used as a short-duration source of heated and pressurized air to which the turbine is subjected. Platinum thin-film pages are used to obtain the heat-flux measurements and miniature silicone-diaphragm pressure transducers are used to obtain the surface pressure measurements. The first-stage vane Stanton number distributions are compared with predictions obtained using a quasi-3D Navier-Stokes solution and a version of STAN5. This same N-S technique was also used to obtain predictions for the first blade and the second vane.
Time-averaged Stanton number and surface-pressure distributions are reported for the first-stage vane row and the first-stage blade row of the Rocketdyne Space Shuttle Main Engine two-stage fuel-side turbine. These measurements were made at 10, 50, and 90 percent span on both the pressure and suction surfaces of the component. Stanton-number distributions are also reported for the second-stage vane at 50 percent span. A shock tube is used as a short-duration source of heated and pressurized air to which the turbine is subjected. Platinum thin-film gages are used to obtain the heat-flux measurements and miniature silicone-diaphragm pressure transducers are used to obtain the surface pressure measurements. The first-stage vane Stanton number distributions are compared with predictions obtained using a quasi-three dimensional Navier–Stokes solution and a version of STAN5. This same N–S technique was also used to obtain predictions for the first blade and the second vane.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.