The Rotamak is a proposed thermonuclear fusion device which employs rotating magnetic fields (RMF) to generate an azimuthal current to produce a field-reversed configuration. The efficiency of the currents that produce the field reversal by RMFs was debated some 40 years ago. The debate revolved around whether the currents would incur dissipation by the conventional Spitzer perpendicular resistivity, or whether some other relation between current and dissipation would be more appropriate. By employing an electron–ion pitch-angle scattering model, we find that the dissipation is non-Spitzer in nature. However, curiously, there appears to exist a regime where the power dissipated to maintain the current becomes vanishingly small.

We have developed a scanning photoluminescence technique that can directly map out the local two-dimensional electron density with a relative accuracy of ∼2.2 × 10 8 cm −2 . The validity of this approach is confirmed by the observation of the expected density gradient in a high-quality GaAs quantum well sample that was not rotated during the molecular beam epitaxy of its spacer layer. In addition to this global variation in electron density, we observe local density fluctuations across the sample. These random density fluctuations are also seen in samples that were continuously rotated during growth, and we attribute them to residual space charges at the substrate−epitaxy interface. This is corroborated by the fact that the average magnitude of density fluctuations is increased to ∼9 × 10 9 cm −2 from ∼1.2 × 10 9 cm −2 when the buffer layer between the substrate and the quantum well is decreased by a factor of 7. Our data provide direct evidence for local density inhomogeneities even in very high-quality two-dimensional carrier systems.

Experiments have demonstrated that a Z-pinch can persist for thousands of times longer than the growth time of global magnetohydrodynamic (MHD) instabilities such as the m=0 sausage and m=1 kink modes. These modes have growth times on the order of ta=a/vi, where vi is the ion thermal speed and a is the pinch radius. Axial flows with duz/dr ≲ vi/a have been measured during the stable period, and the commonly accepted theory is that this amount of shear is sufficient to stabilize these modes as predicted by numerical studies using the ideal MHD equations. However, these studies only consider specific equilibrium profiles that typically have a modest magnitude for the logarithmic pressure gradient, qP≡d ln P/d ln r, and may not represent experimental conditions. Linear stability of the sheared-flow Z-pinch is studied here via a direct eigen-decomposition of the matrix operator obtained from the linear ideal MHD equations. Several equilibrium profiles with a large variation of qP are examined. Considering a practical range of k, 1/3 ≲ ka ≲ 10, it is shown that the shear required to stabilize m=0 modes can be expressed as duz/dr≥Cγ0/(ka)α. Here, γ0=γ0(ka) is the profile-specific growth rate in the absence of shear, which scales approximately with |qP|. Both C and α are profile-specific constants, but C is order unity and α≈1. It is further demonstrated that even a large value of shear, duz/dr=3vi/a, is not sufficient to provide linear stabilization of the m=1 kink mode for all profiles considered. This result is in contrast to the currently accepted theory predicting stabilization at much lower shear, duz/dr=0.1vi/a, and suggests that the experimentally observed stability cannot be explained within the linear ideal-MHD model.

No abstract