In a conventional flat plate solar cell under direct sunlight, light is received from the solar disk, but is re-emitted isotropically. This isotropic emission corresponds to a significant entropy increase in the solar cell, with a corresponding drop in efficiency. Here, using a detailed balance model, we show that limiting the emission angle of a high-quality GaAs solar cell is a feasible route to achieving power conversion efficiencies above 38% with a single junction. The highest efficiencies are predicted for a thin, light trapping cell with an ideal back reflector, though the scheme is robust to a non-ideal back reflector. Comparison with a conventional planar cell geometry illustrates that limiting emission angle in a light trapping geometry not only allows for much thinner cells, but also for significantly higher overall efficiencies with an excellent rear reflector. Finally, we present ray-tracing and detailed balance analysis of two angular coupler designs, show that significant efficiency improvements are possible with these couplers, and demonstrate initial fabrication of one coupler design.

We have fabricated microphotonic parabolic light directors using two-photon lithography, thin-film processing, and aperture formation by focused ion beam lithography. Optical transmission measurements through upright parabolic directors 22 μm high and 10 μm in diameter exhibit strong beam directivity with a beam divergence of 5.6°, in reasonable agreement with ray-tracing and full-field electromagnetic simulations. The results indicate the suitability of microphotonic parabolic light directors for producing collimated beams for applications in advanced solar cell and light-emitting diode designs.