The need for in vivo bone strontium assessment arises because strontium may exert a number of effects on bone, which may be either beneficial or toxic. Measurements discussed here are noninvasive, no sample is taken, nor is there discomfort to patients. The developed source excited x-ray fluorescence system employs a 109Cd source to excite the strontium K x rays, with the source and detector in approximately 90 degree geometry relative to the sample position. The factors affecting the accuracy and minimal detectable limit for bone strontium in vivo measurements are discussed. A system calibration revealed a minimum detectible limit of approximately 0.25 mg Sr/g Ca, which is sufficient for the monitoring of strontium levels in healthy subjects and patients with elevated bone strontium concentrations. Preliminary in vivo measurements in ten healthy subjects at two bone sites (phalanx and tibia) indicated that this system can be applied for cumulative bone strontium estimation while delivering a low effective dose of 80 nSv during the measurement time. Future work will involve attempts to enhance system precision with alternative fluorescing sources and further optimization of the detection system.

An x-ray fluorescence (XRF) system using 125I as the source was developed to measure strontium in bone in vivo. As part of an in vivo pilot study, 22 people were measured at two bone sites, namely the index finger and the tibial ankle joint. Ultrasound measurements were used to obtain the soft tissue thickness at each site, which was necessary to correct the signal for tissue attenuation. For all 22 people, the strontium peak was clearly distinguishable from the background, proving that the system is able to measure Sr in vivo in people having normal bone Sr levels. Monte Carlo simulations were carried out to test the feasibility and the limitations of using the coherently scattered peak at 35.5 keV as a means to normalize the signal to correct for the bone size and shape. These showed that the accuracy of the normalized Sr signal when comparing different people is about 12%. An interesting result arising from the study is that, in the measured population, significantly higher measurements of bone Sr concentration were observed in continental Asian people, suggesting the possibility of a dietary or race dependence of the bone Sr concentration or a different bone biology between races.

Due to signal attenuation in overlying soft tissue, development of x-ray fluorescence systems to measure low atomic number elements, such as strontium, in human bone required a search for a skeletal site with thin overlying tissue. This paper reports ultrasound measurements of overlying tissue on 10 subjects, at four anatomical sites. The average tissue thickness at the finger was (2.9+/-0.7) mm. The average tissue thicknesses were (3.6+/-0.7) mm, (4.8+/-2.0) mm, and (8.4+/-1.7) mm at forehead, tibia and heel, respectively. Additionally, both parametric and nonparametric approaches to the relationship between body mass index (BMI) and tissue thickness suggest that there is a significant linear correlation between the subject's BMI and overlying tissue at the finger and heel bone. These correlations might be used as a criterion to perform XRF measurements, however a larger data set is required to address these correlations more clearly.