Iodixanol (IDX) and iohexol (IHX) have been investigated as possible radiopacification agents for polymethylmethacrylate (PMMA) bone cement, to replace the currently used barium sulphate and zirconia. IDX and IHX are both water-soluble iodine-based contrast media and for the last 20 years have been used extensively in clinical diagnostic procedures such as contrast media enhanced computed tomography, angiography and urography. One of the major reasons to remove the current radiopacifying agents is their well-documented cytotoxicity and their potential to increase bone resorption.Using in vitro bone resorption assays, the effect of PMMA particles plus IDX or IHX to induce osteoclast formation and lacunar resorption on dentine slices has been investigated. These responses have been compared with the in vitro response to PMMA particles containing the conventional radiopacifying agents, that is, barium sulphate and zirconia. In parallel, the in vivo reaction, in terms of new bone formation, to particles of these materials has been tested using a bone harvest chamber in rabbit tibiae.In vitro cell culture showed that PMMA containing IHX resulted in significantly less bone resorption than PMMA containing the conventional opacifiers. In vivo testing, however, showed no significant differences between the amounts of new bone formed around cement samples containing the two iodine-based opacifying agents in particulate form, although both led to fewer inflammatory cells than particles of PMMA containing zirconia. Our results suggest that a non-ionic radiopacifier could be considered as an alternative to the conventional radiopacifying agents used in biomaterials in orthopaedic surgery.

Hydroxyapatite (HA) coatings have been used to improve implant fixation by promoting bone formation around the prosthesis. A macrophage response to HA particulates has been noted around loosened HA-coated prostheses. As biomaterial wear particle-associated macrophages are known to be capable of differentiating into osteoclasts that are capable of bone resorption, we examined whether particulate HA could similarly induce macrophage-osteoclast differentiation. HA-associated macrophages were isolated from granulomas, formed by subcutaneous implantation of HA, and co-cultured with UMR 106 osteoblast-like cells in the presence of 1,25-dihydroxyvitamin D(3) for up to 14 days on glass coverslips and bone slices. HA-associated macrophage-osteoclast differentiation was evidenced by the formation of numerous multinucleated tartrate resistant acid phosphatase (TRAP)-positive cells which formed lacunar resorption pits on bone slices. Polymethylmethacrylate (PMMA) particle-associated macrophages, isolated from subcutaneous PMMA-containing granulomas, caused significantly more osteoclast formation and bone resorption than HA-associated macrophages. These results indicate that macrophages responding to HA particles are capable of osteoclast differentiation. They also suggest that particles derived from uncemented (HA-coated) implants are likely to induce less osteoclast formation and osteolysis than cemented implants.

Trigger finger is due to degeneration and thickening of the proximal portion (A1 pulley) of the flexor tendon sheath, which causes constriction of the flexor tendon. This study reports the presence of localized amyloid deposition in the tendon sheath of 11 of 47 cases (23%) of idiopathic primary trigger finger. Amyloid deposits were only found in patients aged over 46 years old and were present around cells and at sites of mucinous and fibrinoid degeneration which contained highly sulphated glycosaminoglycans. The pathogenic significance of these deposits is uncertain but their small size and presence only in middle-aged and elderly adults suggests that they represent a form of age-associated amyloid deposition.

El objeto de este trabajo fue establecer propuestas de mejoramiento al proceso de planeación de tiempos y costos en la etapa de cimentación de un edificio, a partir de la integración de herramientas como simulación de eventos discretos, programación con líneas de balance y metodologías Building Information Modeling - BIM. A partir de mediciones en campo se levantó información para la elaboración de un modelo de simulación de eventos discretos que imitara el proceso constructivo real. Se propusieron y modelaron alternativas de mejora, a partir de los principios de la filosofía Lean Construction y la programación de líneas de balance encontrando reducciones en tiempo y costo. También se realizó la animación virtual de las alternativas a partir de metodologías BIM. Se concluye que la integración de las herramientas utilizadas es de gran utilidad en la planeación y toma de decisiones en un proyecto civil.