No abstract

The study presents the results of the influence of high-energy ball-milling time on the structure of the new β-type Ti–Ta–Nb–Zr alloys for biomedical applications. Initial elemental powders were mechanically alloyed in a planetary high-energy ball mill at different milling times (from 10 to 90 h). Observation of the powder morphology after various stages of milling leads to the conclusion that with the increase of the milling time the size of the powder particles as well as the degree of aggregation change. Clear tendency of crystalline size reduction at every stage of the grinding process is clearly observed. The X-ray diffraction results confirmed the formation of β phase during high-energy ball milling of the precursor mixture of Ti, Ta, Nb, and Zr. The Rietveld refinement method has shown that both the production method and the atomic radii of the elements used in the mechanical synthesis have influence on the structure. Furthermore, it was found that a broadening of the diffraction peaks with increase of the milling time results from an increase in the crystallites dispersion and an enlargement in the lattice distortion. The results indicate that this technique is a powerful and high productive process for preparing new β-titanium alloys with nanocrystalline structure and appropriate morphology.

No abstract

No abstract

Bi 5 Ti 3 FeO 15 (BTFO), an Aurivillius compound, was synthesized via sintering the Bi 2 O 3 and Fe 2 O 3 mixture and TiO 2 oxides. The precursor material was ground in a high-energy attritorial mill for (1, 3, 5, and 10) h. The orthorhombic system Bi 5 Ti 3 FeO 15 ceramics was obtained by a solid-state reaction process at 1313 K. Phase formation behavior was investigated using differential thermal analysis (DTA), thermal gravimetric (TG), and X-ray diffraction (XRD) techniques. The frequencydependent properties of the material were investigated by impedance spectroscopy. The impedance spectroscopic method is widely used to characterize electrical properties of materials and their interfaces with electronically conducting electrodes. These studies indicate that 1h, 3h, and 5h primary high-energy ball milling followed by sintering is a promising technique for pure Bi 5 Ti 3 FeO 15 ceramic preparation, whereas the ceramics obtained from the substrates after 10h milling is a two-phase material. As the result of this investigation, the model of adjusting the Nyquist charts with a three-element R-CPE (constant phase element) series connection was proposed. It was found that the value of the dielectric constant at the Curie temperature decreases when the milling time of the substrates increases. The decrease in the dielectric constant is influenced by the great dispersion of the grains, their dense packing, and location of particular grains in relation to other grains. Moreover, the change of resistivity with frequency indicates that relaxation processes take place in the material. In conclusion, J. Dercz (B)