Aimed at reducing deficiencies in representing the Madden-Julian oscillation (MJO) in general circulation models (GCMs), a global model evaluation project on vertical structure and physical processes of the MJO was coordinated. In this paper, results from the climate simulation component of this project are reported. It is shown that the MJO remains a great challenge in these latest generation GCMs. The systematic eastward propagation of the MJO is only well simulated in about one fourth of the total participating models. The observed vertical westward tilt with altitude of the MJO is well simulated in good MJO models but not in the poor ones. Damped Kelvin wave responses to the east of convection in the lower troposphere could be responsible for the missing MJO preconditioning process in these poor MJO models. Several process-oriented diagnostics were conducted to discriminate key processes for realistic MJO simulations. While large-scale rainfall partition and low-level mean zonal winds over the Indo-Pacific in a model are not found to be closely associated with its MJO skill, two metrics, including the low-level relative humidity difference between high-and low-rain events and seasonal mean gross moist stability, exhibit statistically significant correlations with the MJO performance. It is further indicated that increased cloud-radiative feedback tends to be associated with reduced amplitude of intraseasonal variability, which is incompatible with the radiative instability theory previously proposed for the MJO. Results in this study confirm that inclusion of air-sea interaction can lead to significant improvement in simulating the MJO.

SUMMARYAn idealized case-study has been designed to investigate the modelling of the diurnal cycle of deep precipitating convection over land. A simulation of this case was performed by seven single-column models (SCMs) and three cloud-resolving models (CRMs). Within this framework, a quick onset of convective rainfall is found in most SCMs, consistent with the results from general-circulation models. In contrast, CRMs do not predict rainfall before noon. A joint analysis of the results provided by both types of model indicates that convection occurs too early in most SCMs, due to crude triggering criteria and quick onsets of convective precipitation. In the CRMs, the first clouds appear before noon, but surface rainfall is delayed by a few hours to several hours. This intermediate stage, missing in all SCMs except for one, is characterized by a gradual moistening of the free troposphere and an increase of cloud-top height. Later on, convective downdraughts efficiently cool and dry the boundary layer (BL) in the CRMs. This feature is also absent in most SCMs, which tend to adjust towards more unstable states, with moister (and often more cloudy) low levels and a drier free atmosphere. This common behaviour of most SCMs with respect to deep moist convective processes occurs even though each SCM simulates a different diurnal cycle of the BL and atmospheric stability. The scatter among the SCMs results from the wide variety of representations of BL turbulence and moist convection in these models. Greater consistency is found among the CRMs, despite some differences in their representation of the daytime BL growth, which are linked to their parametrizations of BL turbulence and/or resolution.

SUMMARYThis paper investigates daytime convective development over land and its representation in single-column models (SCMs) and cloud-resolving models (CRMs). A model intercomparison case is developed based on observations of the diurnal cycle and convection during the rainy season in Amazonia. The focus is on the 6 h period between sunrise and early afternoon which was identified in previous studies as critical for the diurnal cycle over summertime continents in numerical weather prediction and climate models. This period is characterized by the formation and growth of a well-mixed convective boundary layer from the early morning temperature and moisture profiles as the surface sensible-and latent-heat fluxes increase after sunrise. It proceeds with the formation of shallow convective clouds as the convective boundary layer deepens, and leads to the eventual transition from shallow to deep precipitating convection around local noon. To provide a benchmark for other models, a custom-designed set of simulations, applying increasing in time computational domain and decreasing spatial resolution, was executed. The SCMs reproduced the previously identified problem with premature development of deep convection, less than two hours after sunrise. The benchmark simulations suggest a possible route to improve SCMs by considering a time-evolving cumulus entrainment rate as convection evolves from shallow to deep and the cloud width increases up to an order of magnitude. The CRMs featuring horizontal grid length around 500 m are capable of capturing the qualitative aspects of the benchmark simulations, but there are significant differences among the models. Two-dimensional CRMs tend to simulate too rapid a transition from shallow to deep convection and too high a cloud cover.

Abstract. In this paper we define the first Regional Atmosphere and Land (RAL) science configuration for kilometre-scale modelling using the Unified Model (UM) as the basis for the atmosphere and the Joint UK Land Environment Simulator (JULES) for the land. RAL1 defines the science configuration of the dynamics and physics schemes of the atmosphere and land. This configuration will provide a model baseline for any future weather or climate model developments to be described against, and it is the intention that from this point forward significant changes to the system will be documented in the literature. This reproduces the process used for global configurations of the UM, which was first documented as a science configuration in 2011. While it is our goal to have a single defined configuration of the model that performs effectively in all regions, this has not yet been possible. Currently we define two sub-releases, one for mid-latitudes (RAL1-M) and one for tropical regions (RAL1-T). The differences between RAL1-M and RAL1-T are documented, and where appropriate we define how the model configuration relates to the corresponding configuration of the global forecasting model.

Abstract. We describe Global Atmosphere 3.0 (GA3.0): a configuration of the Met Office Unified Model (MetUM) developed for use across climate research and weather prediction activities. GA3.0 has been formulated by converging the development paths of the Met Office's weather and climate global atmospheric model components such that wherever possible, atmospheric processes are modelled or parametrized seamlessly across spatial resolutions and timescales. This unified development process will provide the Met Office and its collaborators with regular releases of a configuration that has been evaluated, and can hence be applied, over a variety of modelling régimes. We also describe Global Land 3.0 (GL3.0): a configuration of the JULES community land surface model developed for use with GA3.0. This paper provides a comprehensive technical and scientific description of the GA3.0 and GL3.0 (and related GA3.1 and GL3.1) configurations and presents the results of some initial evaluations of their performance in various applications. It is to be the first in a series of papers describing each subsequent Global Atmosphere release; this will provide a single source of reference for established users and developers as well as researchers requiring access to a current, but trusted, global MetUM setup.