Comparison of the natural and synthetic phases allows an overview to be made and even an understanding of the crystal growth processes and mechanisms of the particular crystal structure formation. Thus, in this work, we review the crystal chemistry of the family of uranyl selenite compounds, paying special attention to the pathways of synthesis and topological analysis of the known crystal structures. Comparison of the isotypic natural and synthetic uranyl-bearing compounds suggests that uranyl selenite mineral formation requires heating, which most likely can be attributed to the radioactive decay. Structural complexity studies revealed that the majority of synthetic compounds have the topological symmetry of uranyl selenite building blocks equal to the structural symmetry, which means that the highest symmetry of uranyl complexes is preserved regardless of the interstitial filling of the structures. Whereas the real symmetry of U-Se complexes in the structures of minerals is lower than their topological symmetry, which means that interstitial cations and H 2 O molecules significantly affect the structural architecture of natural compounds. At the same time, structural complexity parameters for the whole structure are usually higher for the minerals than those for the synthetic compounds of a similar or close organization, which probably indicates the preferred existence of such natural-born architectures. In addition, the reexamination of the crystal structures of two uranyl selenite minerals guilleminite and demesmaekerite is reported. As a result of the single crystal X-ray diffraction analysis of demesmaekerite, Pb 2 Cu 5 [(UO 2 ) 2 (SeO 3 ) 6 (OH) 6 ](H 2 O) 2 , the H atoms positions belonging to the interstitial H 2 O molecules were assigned. The refinement of the guilleminite crystal structure allowed the determination of an additional site arranged within the void of the interlayer space and occupied by an H 2 O molecule, which suggests the formula of guilleminite to be written as Ba 3 . occurrence is limited to just a few localities. First, these are Musonoi and Shinkolobwe mines in DR Congo [6], two of the minerals were only found in the Repete mine (San Juan County, Utah, USA) [5], and a few more occurrences in Europe could be mentioned (small uranium deposit Zálesí in the Czech Republic, Liauzun in France, and La Creusaz U prospect in Switzerland) [8]. Nevertheless, apart from mineralogy, uranyl selenites are of great interest from the geochemical and radiochemical points of view. It is known that fission products contain 53 g per ton [9] of long-lived 79 Se isotope with a half-life of 1.1 × 10 6 years [10] after three years of nuclear fuel irradiation in the reactor. Thus, an understanding of the processes of mineral formation in nature and their synthetic analogs in laboratories can help in the processing of nuclear wastes. Crystal chemical and structural investigations are key points in such a material's scientific studies due to the essential knowledge of how the variation in the chemical composi...

The complexities of chemical composition and crystal structure are fundamental characteristics of minerals that have high relevance to the understanding of their stability, occurrence and evolution. This review summarises recent developments in the field of mineral complexity and outlines possible directions for its future elaboration. The database of structural and chemical complexity parameters of minerals is updated by H-correction of structures with unknown H positions and the inclusion of new data. The revised average complexity values (arithmetic means) for all minerals are 3.54(2) bits/atom and 345(10) bits/cell (based upon 4443 structure reports). The distributions of atomic information amounts, chemIG and strIG, versus the number of mineral species fit the normal modes, whereas the distributions of total complexities, chemIG,total and strIG,total, along with numbers of atoms per formula and per unit cell are log normal. The three most complex mineral species known today are ewingite, morrisonite and ilmajokite, all either discovered or structurally characterised within the last five years. The most important complexity-generating mechanisms in minerals are: (1) the presence of isolated large clusters; (2) the presence of large clusters linked together to form three-dimensional frameworks; (3) formation of complex three-dimensional modular frameworks; (4) formation of complex modular layers; (5) high hydration state in salts with complex heteropolyhedral units; and (6) formation of ordered superstructures of relatively simple structure types. The relations between symmetry and complexity are considered. The analysis of temporal dynamics of mineralogical discoveries since 1875 with the step of 25 years show the increasing chemical and structural complexities of human knowledge of the mineral kingdom in the history of mineralogy. In the Earth's history, both diversity and complexity of minerals experience dramatic increases associated with the formation of Earth's continental crust, initiation of plate tectonics and the Great Oxidation event.

Uranyl carbonates are one of the largest groups of secondary uranium(VI)-bearing natural phases being represented by 40 minerals approved by the International Mineralogical Association, overtaken only by uranyl phosphates and uranyl sulfates. Uranyl carbonate phases form during the direct alteration of primary U ores on contact with groundwaters enriched by CO2, thus playing an important role in the release of U to the environment. The presence of uranyl carbonate phases has also been detected on the surface of “lavas” that were formed during the Chernobyl accident. It is of interest that with all the importance and prevalence of these phases, about a quarter of approved minerals still have undetermined crystal structures, and the number of synthetic phases for which the structures were determined is significantly inferior to structurally characterized natural uranyl carbonates. In this work, we review the crystal chemistry of natural and synthetic uranyl carbonate phases. The majority of synthetic analogs of minerals were obtained from aqueous solutions at room temperature, which directly points to the absence of specific environmental conditions (increased P or T) for the formation of natural uranyl carbonates. Uranyl carbonates do not have excellent topological diversity and are mainly composed of finite clusters with rigid structures. Thus the structural architecture of uranyl carbonates is largely governed by the interstitial cations and the hydration state of the compounds. The information content is usually higher for minerals than for synthetic compounds of similar or close chemical composition, which likely points to the higher stability and preferred architectures of natural compounds.