Light detection technologies are of interest due to their applications in energy conversion and optical communications. Single-crystal organic semiconductors, such as rubrene, present high detectivities and charge carrier mobility, making them attractive for light-sensing applications. Growth of high crystallinity organic crystals is achieved using vapor processes, forming crystals of arbitrary shapes and orientations and requiring posterior patterning processes. However, patterning the organic semiconductors using industrystandard microfabrication techniques is not straightforward, as these often cause irreversible damage to the crystals. Here the fabrication of patterned micrometric rubrene photosensors is demonstrated through a combination of photolithography and Reactive Ion Etching steps. Protective layers during microfabrication minimize degradation of optoelectronic properties of the organic single crystals during fabrication. Crystals undergoing the patterning process presented a survival rate of 39%. Photoresponse values of up to 41 mA W −1 are obtained under illumination at 500 nm. This opens a route for the industrial-scale fabrication process of high-performance optoelectronic devices based on organic crystals semiconductors.

No abstract

A rapid development in personal electronics has raised challenging requirements for portable and sustainable power sources. For example, in wearable technologies, the concept of wearable body area network brings body motion and vital signs monitoring together in synergy. For this, a key aspect is sustainable portable energy, available anywhere, at any time, as generated by triboelectric nanogenerators (TENG). This technology usually demands high-cost processes and materials and still suffer from low power output, as well as unstable output values due to charge generating stimulus with variable intensities. In this work, we present TENGs using shear exfoliated graphene as electrodes as well as active triboelectric layer deposited by a simple solution process. Graphene in combination with polymers such as polydimethylsiloxane (PDMS) were used to produce TENG devices using low-cost solution processing methods. Device electrical power generation was tested with a cyclic physical stimulus for better control and understanding of device output. The triboelectric response of these materials showed open circuit voltages (Voc) and short-circuit currents (Isc)of approximately 233 V and 731 nA respectively when stimulated at 1.5 Hz. A power density of 13.14 μW/cm2 under a load of 200 MΩ was achieved, which can be 40 times higher when compared to devices made with aluminum and PDMS. These results demonstrate the potential of solution process for low-cost triboelectric devices for self-sustainable wearable portable nanogenerators on health and security applications using contact and positional sensors.