Given the potential for human exposure to silver nanoparticles from spray disinfectants and dietary supplements, we characterized the silver-containing nanoparticles in 22 commercial products that advertised the use of silver or colloidal silver as the active ingredient. Characterization parameters included: total silver, fractionated silver (particulate and dissolved), primary particle size distribution, hydrodynamic diameter, particle number, and plasmon resonance absorbance. A high degree of variability between claimed and measured values for total silver was observed. Only 7 of the products showed total silver concentrations within 20% of their nominally reported values. In addition, significant variations in the relative percentages of particulate vs. soluble silver were also measured in many of these products reporting to be colloidal. Primary silver particle size distributions by transmission electron microscopy (TEM) showed two populations of particles - smaller particles (<5nm) and larger particles between 20 and 40nm. Hydrodynamic diameter measurements using nanoparticle tracking analysis (NTA) correlated well with TEM analysis for the larger particles. Z-average (Z-Avg) values measured using dynamic light scattering (DLS); however, were typically larger than both NTA or TEM particle diameters. Plasmon resonance absorbance signatures (peak absorbance at around 400nm indicative of metallic silver nanoparticles) were only noted in 4 of the 9 yellow-brown colored suspensions. Although the total silver concentrations were variable among products, ranging from 0.54mg/L to 960mg/L, silver containing nanoparticles were identified in all of the product suspensions by TEM.

The utilization of silver nanoparticles (AgNPs) in consumer products has significantly increased in recent years, primarily due to their antimicrobial properties. Increased use of AgNPs has raised ecological concerns. Once released into an aquatic environment, AgNPs may undergo oxidative dissolution leading to the generation of toxic Ag + . Therefore, it is critical to investigate the ecotoxicological potential of AgNPs and determine the physicochemical parameters that control their dissolution in aquatic environments. We have investigated the dissolution trends of aqueous colloidal AgNPs in five products, marketed as dietary supplements and surface sanitizers. The dissolution trends of AgNPs in studied products were compared to the dissolution trends of AgNPs in well-characterized laboratory-synthesized nanomaterials: citrate-coated AgNPs, polyvinylpyrrolidone-coated AgNPs, and branched polyethyleneimine-coated AgNPs. The characterization of the studied AgNPs included: particle size, anion content, metal content, silver speciation, and capping agent identification. There were small differences in the dissolved masses of Ag + between products, but we did not observe any significant differences in the dissolution trends obtained for deionized water and tap water. The decrease of the dissolved mass of Ag + in tap water could be due to the reaction between Ag + and Cl − , forming AgCl and affecting their dissolution. We observed a rapid initial Ag + release and particle size decrease for all AgNP *

No abstract

Silver nanoparticles (AgNPs) are the most widely used engineered nanomaterials in consumer products, primarily due to their antimicrobial properties. This widespread usage has resulted in concerns regarding potential adverse environmental impacts and increased probability of human exposure. As the number of AgNP consumer products grows, the likelihood of interactions with other household materials increases. AgNP products have the potential to interact with household cleaning products in laundry, dishwashers, or during general use of all-purpose surface cleaners. This study has investigated the interaction between surfactant-based surface cleaning products and AgNPs of different sizes and with different capping agents. One AgNP consumer product, two laboratorysynthesized AgNPs, and ionic silver were selected for interaction with one cationic, one anionic, and one nonionic surfactant product to simulate AgNP transformations during consumer product usage before disposal and subsequent environmental release. Changes in size, morphology, and chemical composition were detected during a 60 min exposure to surfactant-based surface cleaning products using ultraviolet-visible (UV/Vis) spectroscopy, transmission electron microscopy-energy dispersive X-ray spectroscopy (TEM-EDX), and dynamic light scattering (DLS). Generally, once AgNP suspensions were exposed to surfactant-based surface cleaning products, all the particles showed an initial aggregation, likely due to disruption of their capping agents. Over the 60 min exposure, cleaning agent-1 (cationic) showed more significant particle aggregates than cleaning agent-2 (anionic) and cleaning agent-3 (nonionic). In addition, UV/Vis, TEM-EDX, and DLS confirmed formation of incidental AgNPs from interaction of ionic silver with all surfactant types.