Solid-state dielectric energy storage is the most attractive and feasible way to store and release high power energy compared to chemical batteries and electrochemical super-capacitors.

Ceramics of composition Ag1−3xBixNbO3 (0.005 ≤ x ≤ 0.040) were prepared by solid state methods and their structure and electrical behavior were characterized with a view to their potential use as high power energy storage materials.

The effect of CH and CD quenching on the luminescence lifetime of Er(3+) Nd(3+) and Yb(3+) in the Cs[Ln(HFA)(4)] system has been quantified, and we have shown that for Er(3+) ions the quenching is dominated by the nearest neighbor CH oscillators, whereas for Nd(3+) ions the roles of more distant CH oscillators and nearest neighbor CD oscillators are important.

No abstract

No abstract

The defect structure and electrical properties of the fast oxide ion-conducting solid electrolyte δ-Bi 3 YO 6 have been studied using a combination of total neutron scattering analysis, energy minimization methods, and AC impedance spectroscopy. Conventional structural analysis using the Rietveld method reveals the oxide ions to be distributed over three crystallographic sites at room temperature, with a small change in this distribution at 800 °C. Analysis of short-range correlations using a total neutron scattering approach yields information on Bi and Y coordination environments. Careful analysis of the angular distribution functions derived from reverse Monte Carlo modeling of the total scattering data reveals physical evidence for a predominance of AE110ae vacancy ordering in this system. This ordering is confirmed as the lowest energy configuration in parallel energy minimization simulations.

A series of semiconducting small molecules with bithiophene or bis‐3,4‐ethylenedioxythiophene cores are designed and synthesized. The molecules display stable reversible oxidation in solution and can be reversibly oxidized in the solid state with aqueous electrolyte when functionalized with polar triethylene glycol side chains. Evidence of promising ion injection properties observed with cyclic voltammetry is complemented by strong electrochromism probed by spectroelectrochemistry. Blending these molecules with high molecular weight polyethylene oxide (PEO) is found to improve both ion injection and thin film stability. The molecules and their corresponding PEO blends are investigated as active layers in organic electrochemical transistors (OECTs). For the most promising molecule:polymer blend (P4E4:PEO), p‐type accumulation mode OECTs with µA drain currents, μS peak transconductances, and a µC* figure‐of‐merit value of 0.81 F V−1 cm−1 s−1 are obtained.

No abstract