A universal post-compensation scheme for fiber impairments in wavelength-division multiplexing (WDM) systems is proposed based on coherent detection and digital signal processing (DSP). Transmission of 10 x 10 Gbit/s binary-phase-shift-keying (BPSK) signals at a channel spacing of 20 GHz over 800 km dispersion shifted fiber (DSF) has been demonstrated numerically.

Recent advances in the areas of Internet of Things (IoT), Big Data, and Machine Learning have contributed to the rise of a growing number of complex applications. These applications will be data-intensive, delay-sensitive, and real-time as smart devices prevail more in our daily life. Ensuring Quality of Service (QoS) for delay-sensitive applications is a must, and fog computing is seen as one of the primary enablers for satisfying such tight QoS requirements, as it puts compute, storage, and networking resources closer to the user.In this paper, we first introduce FOGPLAN, a framework for QoS-aware Dynamic Fog Service Provisioning (QDFSP). QDFSP concerns the dynamic deployment of application services on fog nodes, or the release of application services that have previously been deployed on fog nodes, in order to meet low latency and QoS requirements of applications while minimizing cost. FOGPLAN framework is practical and operates with no assumptions and minimal information about IoT nodes. Next, we present a possible formulation (as an optimization problem) and two efficient greedy algorithms for addressing the QDFSP at one instance of time. Finally, the FOGPLAN framework is evaluated using a simulation based on real-world traffic traces.

Probabilistic shaping based on constant composition distribution matching (CCDM) has received considerable attention as a way to increase the capacity of fiber optical communication systems. CCDM suffers from significant rate loss at short blocklengths and requires long blocklengths to achieve high shaping gain, which makes its implementation very challenging. In this paper, we propose to use enumerative sphere shaping (ESS) and investigate its performance for the nonlinear fiber optical channel. ESS has lower rate loss than CCDM at the same shaping rate, which makes it a suitable candidate to be implemented in real-time high-speed optical systems. In this paper, we first show that finite blocklength ESS and CCDM exhibit higher effective signal-to-noise ratio than their infinite blocklength counterparts. These results show that for the nonlinear fiber optical channel, large blocklengths should be avoided. We then show that for a 400 Gb/s dual-polarization 64-QAM WDM transmission system, ESS with short blocklengths outperforms both uniform signaling and CCDM. Gains in terms of both bit-metric decoding rate and bit-error rate are presented. ESS with a blocklength of 200 is shown to provide an extension reach of about 200 km in comparison with CCDM with the same blocklength. The obtained reach increase of ESS with a blocklength of 200 over uniform signaling is approximately 450 km (approximately 19%).

DPSK phase-and-amplitude regeneration with a NOLM-based phase-sensitive amplifier is demonstrated experimentally. For a highly degraded input signal, maximum differential phase errors were reduced from 82 degrees to 41 degrees , while the SNR was improved by more than 5-dB. Differential phase Q-factor improvement was better than 6-dB. The PSA was operated free of excess noise due to stimulated Brillouin scattering by using a binary phase modulated pulse train as the pump. The impact of pump fluctuations on regeneration performance is clarified. The regenerated signal was characterized by measurement of the constellation diagram by linear optical sampling, giving the first directly measured evidence of DPSK phase regeneration.

Amplification and simultaneous phase regeneration of DPSK signals is demonstrated using a phase-sensitive amplifier. Phase-sensitive gain is achieved in a Sagnac fiber interferometer comprised of nonpolarization maintaining, highly nonlinear fiber operating in the un-depleted pump regime. Both the pump and signal are RZ-DPSK pulse trains. The amplifier is capable of producing greater than 13 dB of phase-sensitive gain for an average pumping power of 100 mW, and easily reduces the BER of the regenerated DPSK signal by two orders of magnitude compared to the un-regenerated signal, corresponding to a negative power penalty of 2 dB. Careful optimization of the regenerator reveals much stronger BER Improvement.