As (Arsenic) is one of the lethal element present at the various locations of the world, putting human beings in danger by polluting the water. Arsenic Kit and atomic absorption spectrometer were used to determine As in ground water of Sindh province, Pakistan. Twenty-Four (24) districts both on the left and right bank of RI (River Indus) were analyzed. It was observed from the results that highest As concentration 200 ppb (parts per billion) i.e. above the WHO (World Health Organization) limit (10 ppb) was observed in Sakrand, district Shaheed Benazirabad followed by Hala, Matairi, TMK (Tando Mohammad Khan) and Nasarpur regions. It was further found that ground water of regions on the left bank of RIwas more contaminated than the right bank. Contour map was created using OriginPro and coordinate systems to highlight the elevated arsenic in the studied area. HRA (Health Risk Assessment) of these areas was carried out to calculate EDI (Estimated Daily Intake), TQH (Target Hazard Quotient) and CR (Cancer Risk). 45% of the total ground water samples analyzed were above the permissible limit for As in water and mostly these are located on the left bank of RI. The local wells in Sindh have never been tested for metal concentration former to use. These results provide baselines for researchers, NGO's (Non-Governmental Organizations) and government to apply arsenic treatment technologies in those areas.

No abstract

Aim: To assess the physical and mechanical properties of plaster of Paris (POP) bandage cast used as a splinting and casting materials.Materials and Methods: POP casts were divided into three Groups A, B and C with 2, 3 and 8 layer for POP bandage, respectively (n=6 in each group). Handling characters, technical easiness or difficulties, setting time, weight, diameter and thickness of the casts were recorded for different groups. The casts were mounted on universal testing machine and axial load was applied @ 10 mm/min until failure. The load deflection graphs were plotted. The maximum force at which failure of the casts occurred was recorded. Stress, strain, modulus of elasticity (MOE) and stiffness of casts were calculated.Result: Construction of POP bandage cast was messy and required 45-60 min for hardening. 8 layer POP cast was comparatively heavier in weight and thicker in cross section than 3 layer cast followed by 2 layer cast. Under axial compression, the load bearing capacity of 8 layer POP casts was more than 2 and 3 layer cast. Conclusion:The values of load bearing capacity, stress, stiffness and MOE of cast were the highest for 8 layer POP cast followed by 2 and 3 layer cast. Use if splints with POP cast is recommended due to its poor mechanical properties.

No abstract

No abstract