There is an urgent need to develop technologies that use renewable energy to convert waste products such as carbon dioxide into hydrocarbon fuels. Carbon dioxide can be electrochemically reduced to hydrocarbons over copper catalysts, although higher efficiency is required. We have developed oxidized copper catalysts displaying lower overpotentials for carbon dioxide electroreduction and record selectivity towards ethylene (60%) through facile and tunable plasma treatments. Herein we provide insight into the improved performance of these catalysts by combining electrochemical measurements with microscopic and spectroscopic characterization techniques. Operando X-ray absorption spectroscopy and cross-sectional scanning transmission electron microscopy show that copper oxides are surprisingly resistant to reduction and copper+ species remain on the surface during the reaction. Our results demonstrate that the roughness of oxide-derived copper catalysts plays only a partial role in determining the catalytic performance, while the presence of copper+ is key for lowering the onset potential and enhancing ethylene selectivity.

Direct electrochemical reduction of CO2 to fuels and chemicals using renewable electricity has attracted significant attention partly due to the fundamental challenges related to reactivity and selectivity, and partly due to its importance for industrial CO2-consuming gas diffusion cathodes. Here, we present advances in the understanding of trends in the CO2 to CO electrocatalysis of metal- and nitrogen-doped porous carbons containing catalytically active M–Nx moieties (M = Mn, Fe, Co, Ni, Cu). We investigate their intrinsic catalytic reactivity, CO turnover frequencies, CO faradaic efficiencies and demonstrate that Fe–N–C and especially Ni–N–C catalysts rival Au- and Ag-based catalysts. We model the catalytically active M–Nx moieties using density functional theory and correlate the theoretical binding energies with the experiments to give reactivity-selectivity descriptors. This gives an atomic-scale mechanistic understanding of potential-dependent CO and hydrocarbon selectivity from the M–Nx moieties and it provides predictive guidelines for the rational design of selective carbon-based CO2 reduction catalysts.

There is an error in the reference list in the PDF version of the originally published article. References [8] and [9] were inadvertently merged during production and are both incorrectly contained within reference [8]. These references are correct as follows: [8] Y.

Carbon dioxide electroreduction to chemicals and fuels powered by renewable energy sources is considered a promising path to address climate change and energy storage needs. We have developed highly active and selective copper (Cu) nanocube catalysts with tunable Cu(100) facet and oxygen/chlorine ion content by low-pressure plasma pretreatments. These catalysts display lower overpotentials and higher ethylene, ethanol, and n-propanol selectivity, resulting in a maximum Faradaic efficiency (FE) of ∼73% for C and C products. Scanning electron microscopy and energy-dispersive X-ray spectroscopy in combination with quasi-in situ X-ray photoelectron spectroscopy revealed that the catalyst shape, ion content, and ion stability under electrochemical reaction conditions can be systematically tuned through plasma treatments. Our results demonstrate that the presence of oxygen species in surface and subsurface regions of the nanocube catalysts is key for achieving high activity and hydrocarbon/alcohol selectivity, even more important than the presence of Cu(100) facets.

Reversible interconversion of water into H2 and O2, and the recombination of H2 and O2 to H2O thereby harnessing the energy of the reaction provides a completely green cycle for sustainable energy conversion and storage. The realization of this goal is however hampered by the lack of efficient catalysts for water splitting and oxygen reduction. We report exceptionally active bifunctional catalysts for oxygen electrodes comprising Mn3O4 and Co3O4 nanoparticles embedded in nitrogen-doped carbon, obtained by selective pyrolysis and subsequent mild calcination of manganese and cobalt N4 macrocyclic complexes. Intimate interaction was observed between the metals and nitrogen suggesting residual M-N(x) coordination in the catalysts. The catalysts afford remarkably lower reversible overpotentials in KOH (0.1 M) than those for RuO2, IrO2, Pt, NiO, Mn3O4, and Co3O4, thus placing them among the best non-precious-metal catalysts for reversible oxygen electrodes reported to date.

The overriding obstacle to mass production of hydrogen from water as the premium fuel for powering our planet is the frustratingly slow kinetics of the oxygen evolution reaction (OER). Additionally, inadequate understanding of the key barriers of the OER is a hindrance to insightful design of advanced OER catalysts. This study presents ultrathin amorphous high‐surface area nickel boride (NixB) nanosheets as a low‐cost, very efficient and stable catalyst for the OER for electrochemical water splitting. The catalyst affords 10 mA cm−2 at 0.38 V overpotential during OER in 1.0 m KOH, reducing to only 0.28 V at 20 mA cm−2 when supported on nickel foam, which ranks it among the best reported nonprecious catalysts for oxygen evolution. Operando X‐ray absorption fine‐structure spectroscopy measurements reveal prevalence of NiOOH, as well as Ni‐B under OER conditions, owing to a Ni‐B core@nickel oxyhydroxide shell (Ni‐B@NiOxH) structure, and increase in disorder of the NiOxH layer, thus revealing important insight into the transient states of the catalyst during oxygen evolution.

Electrochemical hydrogen peroxide (H 2 O 2 ) production by two-electron oxygen reduction is a promising alternative process to the established industrial anthraquinone process. Current challenges relate to finding cost-effective electrocatalysts with high electrocatalytic activity, stability, and product selectivity. Here, we explore the electrocatalytic activity and selectivity toward H 2 O 2 production of a number of distinct nitrogen-doped mesoporous carbon catalysts and report a previously unachieved H 2 O 2 selectivity of ∼95−98% in acidic solution. To explain our observations, we correlate their structural, compositional, and other physicochemical properties with their electrocatalytic performance and uncover a close correlation between the H 2 O 2 product yield and the surface area and interfacial zeta potential. Nitrogen doping was found to sharply boost H 2 O 2 activity and selectivity. Chronoamperometric H 2 O 2 electrolysis confirms the exceptionally high H 2 O 2 production rate and large H 2 O 2 faradaic selectivity for the optimal nitrogen-doped CMK-3 sample in acidic, neutral, and alkaline solutions. In alkaline solution, the catalytic H 2 O 2 yield increases further, where the production rate of the HO 2 − anion reaches a value as high as 561.7 mmol g catalyst −1 h −1 with H 2 O 2 faradaic selectivity above 70%. Our work provides a guide for the design, synthesis, and mechanistic investigation of advanced carbon-based electrocatalysts for H 2 O 2 production.

Production of multicarbon products (C 2+ )from CO 2 electroreduction reaction (CO 2 RR) is highly desirable for storing renewable energy and reducing carbon emission. The electrochemical synthesis of CO 2 RR catalysts that are highly selective for C 2+ products via electrolyte-driven nanostructuring is presented. Nanostructured Cu catalysts synthesized in the presence of specific anions selectively convert CO 2 into ethylene and multicarbon alcohols in aqueous 0.1m KHCO 3 solution, with the iodine-modified catalyst displaying the highest Faradaic efficiency of 80 %a nd ap artial geometric current density of ca. 31.2 mA cm À2 for C 2+ products at À0.9 V vs.RHE. Operando X-rayabsorption spectroscopyand quasi in situ X-rayp hotoelectron spectroscopym easurements revealed that the high C 2+ selectivity of these nanostructured Cu catalysts can be attributed to the highly roughened surface morphology induced by the synthesis,p resence of subsurface oxygen and Cu + species,and the adsorbed halides.